Recent content by e25price

  1. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    eBay JDMplanet has them for sale. Make sure you go to the sellers site on eBay and search for the best deal on the globes.
  2. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I had a similar result after driving the LX for a while. Although I do think my ride improved, it wasn’t as big of a change I was hoping for. I’ll probably still do the globe change in the next six months or so. Overall I’m happy I did it because it was overdue and it helped me get to know the...
  3. e25price

    HELP! AHC Pump Issue After Reservoir Drain/Refill

    Stay strong you got this
  4. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I had similar stuff in the filter, considering I have an ‘08 I just assumed the filter was doing it’s job.
  5. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    Red arrow points to the cap for the filler neck, there is a filter inside of there that I removed with needle nose pliers and a little reverse (outward) pressure. I believe the other part you are asking about is a breather/air relief vent thing. Sorry for the lack of proper nomenclature. I don’t...
  6. e25price

    Help! Code P2442 Secondary AIR System Switching Valve Stuck Open

    Thank you, I believe the Hewitt-tech 2nd gen solves that problem, but I could be wrong. That was the impression that I got by searching a few different threads on this topic.
  7. e25price

    Help! Code P2442 Secondary AIR System Switching Valve Stuck Open

    Just went into limp mode this morning. Checked the code, P2442. 149k on the odometer, 08 LX. It stays in the driveway each night and we have had a ton of rain lately due to the hurricane. Not really wanting to spend $3500 on it. I’m going to be ready to clear the code and see how the next few...
  8. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I had a few 10mm wrenches, I used the shortest one and fished around for the best angle. I also sprayed with penetrating oil a few days before. If I was to do it again I would invest in one of the extra short wrenches, it would be worth it. Mine wasn’t hard to open from a tightness aspect.
  9. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    Just took her out for a test drive, definite improvement to the ride. Glad I did the flush first vice spending the money on globes until I have to. Glad the fluid I bought looked good and is performing. Used about 4.5 liters.
  10. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    Used a heat gun and a hole punch to open up the bleed tube a little bit, as soon s it stops raining here in Pensacola I’ll see if it fits better on the bleed nipple.
  11. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    Used a brake bleed tube and had a little trouble getting it on the front bleed valves. Due to the location of the rear valves I couldn’t get enough pressure to push the tube in. It was dark anyway so I will need to finish tomorrow. I’m through three liters so far. Let me know if I’m missing...
  12. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    Filling the resevoir was a PITA. I tried it with the filter in and I was spilling fluid everywhere. I took it out but still had to go very slow. I was able to stick the clear tube from the pump way down the filler tube. When fluid started to back up I could hear it gurgling so I would stop and...
  13. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I did not drain the reservoir. I was concerned about extra air getting in the system. I don’t know how much fluid gets ported back to the resevoir (if any) but I’ve heard other people say it doesn’t. If that’s true the resevoir fluid should be pretty clean so no need to take it out.
  14. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I did this procedure in my driveway. All I had to get some extra height was two rhino ramps. My thought was if my goal is to get air bubbles might as well have the front wheels elevated since I am starting up there. Someone smarter than me can tell us if this is a bad idea or not.
  15. e25price

    LX570 AHC “Basics” - Added as sticky thread for AHC Issues

    I bought a transfer pump from autozone to pump fluid out of the jar and into the reservoir. If you are planning on doing this procedure drop the spare and put the flashlight behind the reservoir for backlighting. I’m lazy and I didn’t drop the spare and I had to go back a few times to wrestle wi...
Back
Top Bottom