Recent content by DBasher

Tried to install my headlight wiring harness, got frustrated, took a picture. lol Cheers

I'd call up ICON and ask what the deal is. 1) They may have real issues (most likely they don't) and you'll hear it directly from them. 2) If they have a dealer that isn't delivering they would love to know about it. You'd be surprised how many shops rob Peter to pay Paul and are on the verge...

37's on a daily works well for me.

I drove from the Seattle area down to Utah for Speedweek on the salt flats, the rain came and at first it was postponed, more rain on Saturday and the event was officially cancelled. Spent some time wandering the mountain range above the flats and exploring around Wendover before heading toward...

Thank you. I did not. I thought it would be horrible and even went so far as to get quotes to go to 4:88’s. For what I use the truck for it’s just fine, that being said, I may do a lower transfer case gear set if I decide to beat on this more than my Jeep.

New rear lowers from SPC....should’ve done it months ago, lol

3” Icon, 17”x8.5” Method w/37”x12.5 BFG’s Rubs on full stuff but not enough to worry about right now.

It’s sitting on an Icon 3” and does rub on full stuff, not horrible and really not enough for me to do anything about it right now.

I wanted to add some detail about the Method 704’s I purchased. The center bore isn’t quite large enough to fit over the front hubs, a lil machine work is all that’s needed...essentially only taking off the lip the center cap snaps into.

thank you! The sliders are White Knuckle and besides looking good, they work well too.

Method 704’s-17x8.5, 0 offset 37x12.50-17” BFG’s

Bit of a Jeep weekend but jumped back into the 80 for a trip to a friends job site today. I’m smelling oil while sitting at a stop so that’s something that’ll need some investigating.

Got to test out the new rig in the hills this weekend, good times.