Recent content by cj10

Have you had any issues with the bolts catching on anything since they hang below the sliders?

That seems like a great place to add some USB's. You are a machine at rolling these things out.

I know nothing about 3D printing so just out of curiosity how much time goes into producing parts like you are coming up with. Like design hours and how long does it take to print. Thank you for everything you are doing

Vehicle speed sensor 2. Is that part 89413-60020 or part 89413-32010. This is for a 1999.

So I am confused now. I just looked up parts on this website ToyoDIY.com and came across part 8413-60020. I thought I needed the one in the title. I got a P500 code with a dead speedo / tach / and odo. I did not realize there was multiple sensors.

The one I currently have has Toyota printed on it. If it did a 90* towards the rear of the car I think it would work. It is just impossible for it to go forward due to the transmission ribs.

That is not the part. That is the transfer case speed sensor. The transmission speed sensor looks like this

How much for the transmission revolution (speed) sensor?

So I think I need a new sensor. Part 89413-32010 now part 89413-32011. My factory part on my '99 has a straight plug all the pictures I see show the plug at 90*. I ordered a cheap knockoff part 89413-32010 and it won't work because it is one of the 90* ones. When I shop for the OEM part they...

I did the MC rebuild due to double pumping the brakes (no CEL codes) and they worked well for awhile. Then I started to get the ABS Brake light again and the pedal went soft. I thought maybe I hadn't bled the brakes well enough. I timed the booster motor and was getting intervals all over the...

I found the grounds and checked them. Both look good. I did come across this while following the ground from the fuel pump (black wire red stripe) Pretty sure Toyota did not do this. Here is the jumper for reference

Can anyone tell me where ground EC (Right rear bank of cylinder head) is located. I have looked back there and don't see it. Also ground BM (left rear side quarter panel). This is on a 1999. I am looking at the Electrical Wiring Diagram but I am not very good at reading it yet. I know I...

I have a W123 as well. Such a great car in all of its quirkiness. I love how everything is mechanical on it

That's correct you do not need to pull the MC to adjust the push rod. That was my issue though it was too far out not allowing brake fluid back into the reservoir

I see the $128 but if you add to the cart it keeps the old pricing