Recent content by AZExplorer

How's it towing with the 17's? Love that look, but may do the 18's instead.

Yes good point, always know the laws before dumping anything. I guess if my capacity wasn't so small I wouldn't have much issue. Having a diverted to flow grey to black as wanted would be best of both worlds.

That is correct on the grey/black. What we did is capture most the grey by putting a tub in the sink then dumping outside when done washing dishes, etc. Still, I'd love to have a separate tank and may research it. I imagine someone has done the mod already. The access looks very straight...

Funny that is the exact same model we were considering! Would also like to hear how you liked it! My son really wanted the bunks

We debated for a long time between this and more traditional trailers. After one trip and countless hours of research, here is my take. I tried to be critical, but we absolute loved our first trip. It was in the 30s at night and slept well with furnace at 68 all night. After 4 days, we only used...

This has been such a good thread to read. Just completed our first trip. Using WD anti sway hitch, it’s towed beautifully. I kept in S4 or lower on nearly any incline and for engine braking. My tongue is still sitting just slightly too high, think I’ll need a bigger drop on the hitch. averaged...

I'm having a hard time here. Is this it? I have a 2013 LX and the photos I have seen, none seem to match up to what mine looks like. Stuck on where to connect. This is directly behind the panel of features on the left hand side above the coin tray. It's the only brown tape I'm seeing.

Yes, I believe it would be deactivated by holding it down for three seconds when not moving. After researching a bit more, sounds like general consensus is to leave on as it shouldn't ever actually activate with proper set up. My neighbor recommended it off, which seemed counterintuitive so...

General consensus to turn OFF trailer sway control when using a WD anti sway hitch? See that is recommended a few other places. I picked up the redarc tow pro, but don't have an extra spot to install it! May have to go with another system or get creative.

This whole kit by hop This kit by Hopkins is just strange. Why did they not map it to the existing ends? Secondly, When I plug in further up stream the kit isn't long enough to reach where its installed OEM. I'm not sure how you got your kit mounted so far to the right, my kit isn't that...

Please let em know about the next one!

295/55R20 was a no go. Rubbing UCA and plastic. Back to drawing board.

How hard is it to install spacers, if needed? For someone far from a mechanic.

LT295/55/R20 installing tomorrow! Thanks all for the recommendations. I think this is a good balance for my use case.

So the trailer hasn't been finalized yet, but the current one I'm looking at is under 7k (6995 lbs) and 504 hitch weight (I messaged you about this couple weeks ago). As far as use case, its to take road trips, get out doors and get out of the Phoenix heat in the summer. I'm not planning on...