Recent content by 405

Love the look of your 40. Can't wait to see it with the soft top.

Thanks all for the replies. Going to the alignment shop today to see where my caster is.

Here is a pic of how the front shackle sits below. No quite vertical. I haven't done the TRE but they seem to be okay. They don't look or feel worn out. May be worth replacing anyway? I can get some more pics. Looks like I need an angle finder or an alignment shop. There were a couple posts...

Thanks. Yes, I will need to get the pins too, thanks for the reminder. To address the steering I've done the following: Center arm rebuild, front knuckle rebuild, OME steering damper, and tightened up the steering box. The steering feels ok, it's just the wandering and nervousness I'm trying to...

Hey All, I am having wandering steering issues on my FJ40. All of my research here on Mud leads me to believe caster shims on the front axle may fix my problem. I have a 2" OME lift on 33" BFGs and it can be tough to keep it from wandering at speed (50-60mph), especially on uneven or rutted...

Looking forward to your review.

I was planning on listing my blue '78 on BAT within the next month or so if you're looking for something pretty much "done". No rust, 2F, 4spd manual, and hardtop.

Following. Coming from the 40 section, its good to see an 80 being restored!

Can you message me with how much shipped to 60901 for both rear tail light assemblies with the harness? (I dont need the lenses). Someone hacked my stock one on my 60 for LED's and I would like to convert back to stock bulbs but I need the harness to splice in. Thanks

Bump!

Bump! $200 + shipping on the Jerry Can

Gorgeous truck. Can you share your suspension and tire setup?

Very sweet truck! Love UN look with the grille and the steelies. Seller is legit as they come. GLWS! Wish I could add this one.

Correct. My truck is a '78 General Markets/Columbian spec that I am Americanizing. It came with the split front bench and long jump seats, no roll bar. To install the US spec buckets, short jump seats, and roll bar new holes needed to be drilled for just about every mount to bolt everything up...

Bump! $300 + ship