Builds Out with the old and in with the new!(turboed 2h!) (3 Viewers)

[mongoose2231]

And done.

 

[mongoose2231]

Box is done and back together.
Now to reassemble everything.

 

[mongoose2231]

Dash is slowly coming along. Them heat controls are such a paint o thread through places an such!!

 

[pistonpete]

Coming along nicely ! I like the 70"s wheel.. I invented a few new words working on the dash controls also... Haha

 

[mongoose2231]

You know, I had this dash apart before. I thought I wouldn't have to open the thing again
Now, here I am...lol

 

[mongoose2231]

My original dash support was cut by some PO, so I took the time to weld in a piece I cut out of a spareI had laying around. I'd have used the spare, but it is grey.

 

[mongoose2231]

More of it is done! Radsupport , radiator, ps pump.other odds and ends under hood. Getting close to turning the key to check that all systems are good.

 

[pistonpete]

Yes sir !!

 

[mongoose2231]

Starting to look like a car, pheeew...
Got some new Koytos in the buckets. They were a gift from my buddy @Beno. Finally getting to use them. Thanks Onur!!

 

[mongoose2231]

dash is in.

 

[mongoose2231]

Next is fuel tank and batteries to give the old girl a go.

 

[mongoose2231]

Fuel tank is on but not after brand new oem sender and fuel pickup, replaced the clutch slave with a brand new one I found in my stash, got the fuel line connected, bolted the front fenders fully, swapped the AC switch with a spare, mine was hacked, etc, etc. Getting there. Hoping to get fuel in it tomorrow and give it a go. I have to install the battery trays and get some new batteries to see if she turns.
Cheers all.

 

[duncanrm]

. Getting there. Hoping to get fuel in it tomorrow and give it a go. I have to install the battery trays and get some new batteries to see if she turns.

Very cool.. check the intake for rags!

 

[mongoose2231]

There are rags in there. I'll make sure to remove the.rags.