I am working on my hydroboost install. The unit is installed, but I have not yet hooked up the hydro hoses. I mounted the brake master after bench bleeding it then bled the system using a power bleeder (Air pressure on top). I climbed in to test the pedal firmness and there was none. I only felt expected back pressure from the internal return springs. The pedal went down until hitting a stop.
What kind of pedal firmness should I expect to feel at this point? Should it be rock hard if properly bled?
Next question, the pedal went down a ways then bottomed against a hard stop. I am not sure if that is an internal stop on the HB unit or not. I didn't expect that since I used to be able to go nearly to the floor (if air in the lines, etc.) with the old system.
Thanks!
What kind of pedal firmness should I expect to feel at this point? Should it be rock hard if properly bled?
Next question, the pedal went down a ways then bottomed against a hard stop. I am not sure if that is an internal stop on the HB unit or not. I didn't expect that since I used to be able to go nearly to the floor (if air in the lines, etc.) with the old system.
Thanks!