FJROSS

I would like to be on the list when the first batch of the exhaust is ready. So, if I understand this correctly, you will have a bunch of (exhaust only) going out to the original 16 customers who purchased the header already and need them... correct.

Just checking, will the first purchaser’s of the original batch of 16 headers be first in line for the balance of the exhaust system? I know it’s mentioned that the exhaust system is not able to be purchased separately, but I hope this isn’t the...

Are the first people who purchase the header first in line for the set of full exhaust? Is there a time line on rest of exhaust and pricing?

Who is the go company for a 1977 rear sill? I think I only need the cover and not the bottom reinforcement. Thanks, Dave

Thanks, I was looking for the hold down bolt that attaches the bracket to the block. I called my dealership and the part number for the bolt is 90080 11675.

Would anyone have the distributor hold down bolt Toyota part number for a 77 and know if it's still available from the dealer? Mines a little worn and tired.

I use Grundy

Thank you. Now to see if they are still available. Thank you for the information. That part number is superseded by 90080-11675 and is still available. Around $1.50 each.

Would anyone happen to know if the hardware is still available from Toyota or another vender. These are the 8x1.25 20mm long self tapping bolts with capture washer/lock washers. The head is marked with the #4. Thanks Dave

Mark, Just a sanity check for a 1977 40. The bolt hole center on the pully should be 2-1/8" if I am correct for the (no fan clutch) 6-3/16 long water pump?? Would you also have the exhaust manifold insulation shield for the front side. Attached...

Looking for 2F dual water pump pulley for 75 and later models. I believe the bolt hole center should be about 2-1/8". See attached picture. Thanks, Dave

Kurt, Can you confirm which Aisin water pump I would need to purchase from you for my March 1977 build no oil cooler and no fan clutch. would it be the 61070??

kurt, Attached finds picture of pump and box it was shipped in.

My bad, I mis-typed the part number. It's 61071 that's printed on the box . I purchased this back in 2008. It looks to be an exact replacement for the one that came with the engine when I purchased it, except the current on the engine has a...

Hi, Can anyone elaborate on the differences between Aisin water pump 61070 and 67071? I purchased the 67071 years ago for my 77 with no fan clutch and no oil cooler. I believe I have the original (with oil cooler connection capped off) and the...