ARCHIVE Wits’ End Fire Extinguisher Mount and Locking Lid

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Remind me on cost

SierraWheeler: your the first one I noticed that has addressed the vapor problem @ the source. I can't remember off the top of my head, but your '01 has the canister where? You probably have one, but can you steer me to write up with P/n's etc?

Check this thread --> Charcoal Cannister Valve

I'm an '01, canister is under hood next to fuse box. Evap VSV, Vapor VSV, and Vapor Pressure Sensor control the flow of fuel vapor through your evap system. I can scan and send you my FSM if needed. It describes in great detail how to troubleshoot the system and when to replace parts. I did everything myself and paid ~$700 in parts.
 
Amazing...and cool...
 
So as it turns out, the PS and DS are NOT ambidextrous. Bummer. PS mount requires a curve to clear a hump in the floor. The first few images show the PS mount in place. The last image shows the two different mounts which the PS in blue.

100 FEM Pass Side Iso 1.jpg
100 FEM Pass Side Iso 2.jpg
100 FEM Pass Side Iso 3.jpg
100 FEM LH vs RH 1.jpg
 
Thanks for the clarification on the passenger's side versus the driver's side. If you are building both, I put me down for one of each.
 
*bump*
 

Users who are viewing this thread

Back
Top Bottom