Whistle and Soot. 12HT Cast Manifold!

[duncanrm]

Very nice.. Whistle and Soot have their own CAST manifold for the 12HT now..

Whistle 'n' Soot | Toowoomba QLD - https://www.facebook.com/whistlensoot/

Australia is firing on all cylinders with aftermarket 2H/12HT parts this week!

 

[ceylonfj40nut]

I take it this plumbs on a 2H like it would on a 12HT to allow turbo as in 12HT?

 

[duncanrm]

I take it this plumbs on a 2H like it would on a 12HT to allow turbo as in 12HT?

Worth confirming with Whistle and Soot directly.. I think the comment I've seen in this regard is

"it is also compatible with low-mount CT26 turbo setups on 2H engine conversions. " ..

However its possible the resultant turbo position may not be ideal for a 2H.. message their Facebook page for more info is my advice.

 

[cruiserpilot]

Do they have allowance for Pre-Turbo EGT fitting? I don't see one. On the factory it's a bit awkward trying to get
the sender in the middle of the 3+3 flow due to factory webbing inside?

 

[cuteo100]

Do they have allowance for Pre-Turbo EGT fitting? I don't see one. On the factory it's a bit awkward trying to get
the sender in the middle of the 3+3 flow due to factory webbing inside?

Agree, it is awkward and not the best location.

 

[cruiserpilot]

Agree, it is awkward and not the best location.

View attachment 4159590

I'm moving mine. I've been going back and forth with someone from W'n soot on FB. Next stop is asking Graeme @ GTurbo.
Currently on rear of divider and getting temps that are disproportionately higher than what others say they get. Truck runs fine.
No issues just lack of trust in the numbers on EGT now.