Wheeling ? 1

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 6, 2004
Threads
234
Messages
4,449
Location
Bozeman, MT
Ok so I took out the cruiser today for the first time. And I had some issues that I would like to resolve. I am going to ask each in a different post so as not to get multiple answers going around at once. So this one is to figure out why she died and wouldnt restart and I had to get towed out. We checked the coil and it wasnt sparking. But when we disconnected the wires to it they wouldnt spark on each other so its like the coil wasnt getting power. One of the guys also suggested that the distributor may have been the problem. So just want to hear what you guy have to say anything to check anything you want me to tell I forgot to help me figure it out. Thanks
 
Step 2. Complete the circuit. Cut a fresh wire from coil negative to dist-points ground. You'd be surprised how many people miss the importance of this little wire.
 
If it was breaking up real bad before it conked out you could have fried the condensor. Before I realized I needed a ballast resistor this happened to me a few times. Had power to the coil, but no spark because it had no signal from the dist.
 
Make sure the points are not fried. If you let it set with the key on while trying to figure it out, you can smoke the points really bad, including all the wiring to the points. I did this twice before I realized what the H*** was happenning. Make sure you gap is correct and isn't changing due to a wore dizzy.
 
Back
Top Bottom