what's this carb part?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 1, 2004
Threads
237
Messages
1,677
Location
Iowa
ooooh, aaahhhh, a pretty new rebuilt carb fresh from JimC...

this is stock 79 fj40 to replace a PO's Holley setup - what is the piece I'm touching in the pics with two vacuum connections? What use in a desmogged rig?

It appears not to have any connections to the carb itself other than being bolted onto it. My other 79 (I believe stock carb) doesn't have this, and neither do a couple fj60's I checked.

thanks
 
It is an emissions control part. I have it on my 2/80 FJ40. Interesting enough, I cannot find a part explanation in the emissions manual. The port goes to the air cleaner "doughnut" section of the air cleaner.

The reason you do not see it on your other carbs is because it was only used for a short period of time.

Juke
 
thanks Jukelemon - I expect that's right

there are two vacuum ports, one pointing up and one down... if one goes to the aircleaner then where does the other go? And what's the proper name/function?

rhetorical questions since I'm desmogged and will expect to pull it off, but I'm curious.

anyone else got more info?
 
Last edited:
erics said:
there are two vacuum ports, one pointing up and one down... if one goes to the aircleaner then where does the other go? And what's the proper name/function?

rhetorical questions since I'm desmogged and will expect to pull it off, but I'm curious.

anyone else got more info?

No, no no! I left that on for a reason. The device in question is the HIC valve, Hot Idle Compensator. It needs to have a short section of vac hose connected to the air cleaner right beside it, and a slightly longer hose from the bottom port down to the intake manifold under the carb.

When the truck is idling on a hot trail, the HIC will open up, allowing a slight vacuum leak which raises the idle speed slightly to compensate for the tendency to get low & stumbly when underhood temp is high. Like the PCV, it is a good emission device.

BTW, carburetor is a French word. Translated into English it means "Do not touch!" :cheers:
 
FJ40Jim said:
Actually, Eric's carb is a 01/79-7/80 fed spec.

The SOR picture of the '79 carb is missing the HIC and has the choke opener linkage assembled backwards. But hey, you gets what you pays for. :)

Thanks for the correction, Jim, you are the Master o' Carbs, no doubt.

As a side note, the HIC moved from the side of the carb to the underside of the air cleaner, and went from metal to plastic - not an improvement.

I need to replace mine on my 1982 FJ40 - an exhaust leak cooked it to a crispy crunch!

Kirk
 
FJ40Jim said:
...The device in question is the HIC valve, Hot Idle Compensator. ... "Do not touch!" :cheers:


Isn't that what I said? "Pyromagnetic air flux capacitor" "Hot Idle Compensator" same difference! Sounds almost the same - pretty funny since I just made it up out of complete ignorance. Now stop touching it! :D
 
Back
Top Bottom