What would you do?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2007
Threads
103
Messages
727
Location
Air Capital of the World! Wichita, Ks/Choctaw, Ok
I have a LX with a bad motor, but I'm getting ready to buy a wrecked LX with a good motor and 60,000 miles less. Should I pull just the motors to replace or pull the complete drivetrain, motor, tranny and transfercases? and GO!

ps: putting an LS engine in is not an option at this point!
 
I've never done it, but after reading through several threads on the topic, it seems to move everything at once is a much easier option.
Consider cleaning, painting and changing gaskets, etc on the good engine when you have it on the hoist. then you get to drop in a refreshed, sealed unit as replacement and you don't have to fight the rest of the stuff being in your way
I might be wrong, but you should be able to leave the old wire harnesses in place too.
 
That is what I was hoping to hear! ^^^
While I have it out, I should replace?
Water Pump, Valve Cover Seal, Plugs/Wires, PHH, Oil Pump seal, Crank Seal

This will be for resale so I don't want to get carried away! If I were to keep it I'd do a preventive HG change.
 
if you are planning on selling it then just fix the basic things it needs. if it was to keep then i would do starter and alt, all hoses, maybe a HG, rear heater lines, go down the rabbit hole, end up broke, get divorced, upgrade interior so i could sleep in it... the list never ends :flipoff2:
 
Water Pump - No, Not hard to change with motor in.
Valve Cover Seal and PCV Grommet - after checking condition
Plugs- go ahead, they are cheap. Check Resistance on wires and for cracks. Replace with OEM or NGK
Rotor and Cap - Evaluate
PHH- Your dumb not to
Oil Pump Seal - No doubt, Have to remove Crank Pully to do oil pump.
Crank Seal- Might want to crack big nut loose while motor still in vehicle using starter
Upper and lower oil pan gaskets - Can't think of a better time
Radiator Hoses and Belts - Evaluate
Heat Valve on Firewall - Evaluate, ~$70 and easy job with motor out
Check condition of Rear Heater Hoses, super easy with motor and trans out, super hard with it in place. Gates or Silicone recommended
Chk motor mounts for cracks
Fuel Filter - Yep
Wrap Main Harness by EGR with heat resistant tape while you have motor out ($20)
Change oil in Fan Clutch - Cheap if you have the time.

All these items would be worth raising your Selling price to show they were bad and replaced.
Take pics of old items to give buyer confidence.
 
Last edited:
Make sure to unplug main harness from computer in pass side dash. Take out and put in with it on engine.
Get new studs and nuts exhaust manifold to y pipe. They tend to be shot.
 
Back
Top Bottom