What have you done to your 200 Series this week? (18 Viewers)
- Thread starter MScruiser
- Start date
-
- Tags
- 200 series
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
That's the intent........ eventually!
But don't hold it against me if I show up in the 100 another time or two.
Purchased this 2016, added heritage/trd wheels and KO2s. Leveling kit and black vinyl wrap over the chrome door trim happens next week. Still debating the running board delete.
Stedi Lights mounted, waiting on the dash swit
ch to finish wiring them up.
Still need the mean smiley face covers. They aren’t Stedi until those are on!
Fixed my center console veneer a while back but didn't mess with the other lifting stuff. Mask the edges with electrical tape, place glue with toothpick, and hold tight for a minute to get it tight again. Wet sand any glue residue and polish it out.
Mine is starting to delaminate along the memory buttons and in the center console by the seat heat/cool. Inspired to see you do this!
Thanks to the advice of this group, replaced the following on my 570 this week (@ 136K miles):
Untitled by jeff elliott, on Flickr
Untitled by jeff elliott, on Flickr
- Radiator and associated hoses
- Idler pulley, tensioner and belt
- Thermostat
- Water Pump
- Fan Bracket
- Oil & filter
Untitled by jeff elliott, on FlickrUntitled by jeff elliott, on Flickr
Thanks to the advice of this group, replaced the following on my 570 this week (@ 136K miles):
- Radiator and associated hoses
- Idler pulley, tensioner and belt
- Thermostat
- Water Pump
- Fan Bracket
- Oil & filter
So dang clean in there!
Picked up a new toy for the LX. Showed up this morning. Took 50 min to get to the test temp inside the house.
Interesting how the doors open up alternating like that. Can you have them both open the same way?
Yes, they will open left, right or remove completely
The WKOR sliders look great! Are they angled?
Thanks! Yes, 15° angle.
Installed wind deflectors / sun protection (not sure that's the correct term).
They are from OCAM and the shipping was the same as the purchase price. That's one of the downsides of having a 200 in Switzerland. It still felt cheap/reasonable because of how expensive Switzerland is.
They are from OCAM and the shipping was the same as the purchase price. That's one of the downsides of having a 200 in Switzerland. It still felt cheap/reasonable because of how expensive Switzerland is.
Last edited:
@swiss200 - love the Braid Winrace wheels, what’s offset and wheel specs?
It’s just once a year but it feels like I’m always working on these damn headlights
Have you considered an Xpel headlight film…it has UV protection and won’t yellow!
I used the Meguiar’s headlight coating/UV protection! Maybe I’ll double up with Xpel?
Iv
Im with ya. Ive had a new pair of OEM in my cart for about 6 months. Just can’t stomach the price but mine are beyond repair now.
