Wow! you got more cowbell AND a black cat bone!
What did you do to your pig today?
- Thread starter ABQIRONPIG
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Wow! you got more cowbell AND a black cat bone!
Is the idea of the bell that it warns you by hitting anything the pumpkin will.
Yup, that's the idea.
Over the past few days my son & I changed the oil, swapped the oil filter, super-douched the K&N, & cleaned the carb. Today we swapped the plugs, put in a new fuel filter & installed a new rubber pad (the VW one that SOR sells) on the accelerator.
All super-simple maintenance items but what a difference. Sounds like a finely tuned tractor & the accelerator pad led to a huge gain in our 0-60 times.
All super-simple maintenance items but what a difference. Sounds like a finely tuned tractor & the accelerator pad led to a huge gain in our 0-60 times.
I don't know about how they came from the factory, but mine never had one. I have had my foot slip off it when wet or snowy & I am trying to "teenage-driver proof" the truck.
jdog35 said:
Can we see a close-up?
Did you have to cut sheet metal for this?
P/N on the LED?
to fit flush you would have to cut sheetmetal since the reflector sits on top of a raised sheetmetal section.
Close up forthcoming once it stops raining
And they are Peterson 2.5" round grommeted LEDs.
better get actual paint on there. primer is porous and holds moisture.
so not actual s/t/t lights. how are you going to work brake and t/s lighting?
Roger on the paint. Meant to say paint but was looking at the primer can when i was typing. 
They will be running lights. I am putting my reverse an brake/turn signals in the bumper I'm almost finished building. I also thought about putting some rectangular brake/turn LEDs in the current blank spot higher on the fender. Still trying to figure what to do with that area (i.e. rounds vs rectangles vs...?).
They will be running lights. I am putting my reverse an brake/turn signals in the bumper I'm almost finished building. I also thought about putting some rectangular brake/turn LEDs in the current blank spot higher on the fender. Still trying to figure what to do with that area (i.e. rounds vs rectangles vs...?).
my pig in process of rust removal
Here is my baby getting the rust cure
Here is my baby getting the rust cure
Bob - those look sweet! Just don't get any rock chips, or you'll have to do it all over again! 
took off my beadlock rings and gave them some color
Was that the only color you had?
Like the colour or not, lite blue is eye catching
its the 09 fj voddoo blue its a lot darker it just looks lighter in the pic. its going to match my fj
