Water Pump Problem’s

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 24, 2011
Threads
17
Messages
308
Location
Saint Johns, Florida
I’ve installed this water pump 3 times; once without any rtv sealer and once with it on both sides of the gasket and copper coating and the last time without any treatments at all. Every time it has leaked from the same spot; the bottom bolt. At this point I’m at a loss for what to try next. Maybe I’ll just sell it. :bang:
 
I had a new W.P. leak between the backing plate and the pump body. Had to remove the plate from the pump and seal it. Then searching around here I found it’s not so un-common and some guys just remove and seal the back plate any time they install a pump. Maybe yours is leaking there.
 
Ok thanks guys, I haven’t tried that yet. I just used some Toyota fipg sealer between the pump and gasket surfaces and I’ll let it cure tonight and try again tomorrow. I’ve made my own gaskets the past 2 times and they seem to hold up better than the others.
 
Yep, the rear plates sometimes leak. I even had one where one of the rear plate bolts was crooked in the hole ! You might also try putting a piece of sandpaper on a very flat surface and run the legs of the water pump over the sandpaper and see if you have contact on the entire mating surfaces where the gaskets belong. Sometimes the machinists forget how to do their jobs.
 
Put some fipg on the threads of the bolt where the leak is. IIRC that bolt goes into the water jacket.
 
Some years back I got a call from @brandon61 about doing a head gasket on his 40. During the course of the conversation he mentioned that he found this puddle of coolant underneath the truck after a local mechanic changed the water pump. Hmmm

I happened to have a drive scheduled through his area a couple of weeks later, so I told him not to anything hasty, and I would stop by and have a look. It only took one look for me to be certain it was not the head gasket. I told him to pull it, seal the backing plate himself and reinstall.

Never did end up doing that head gasket. ;)

And Simund ordered a bunch of parts from me as his way of repaying me for my diagnosis. :)
 
Yep, you guy’s are right on the money. I pulled the pump and the gasket was mated to the block pretty good. So I pulled the back plate off and put fipg Between the plate gasket and pump but not the backing plate. Then I put some between the block gasket and the pump but not the block. Filled it and burped it and no leaks. I’ve been driving around running errands with it all day and everything looks good. Hope this thread will help a few more guy’s out.
 
I’ve found that non-Aisin water pumps are more problematic. I’m betting your is an Airtex or similar?
It was actually new from My local Toyota dealer where my dad used to work. I threw his name out and got it for $150 instead of $200. I’ve also seen on here where guys have had good luck with Napa in finding remanned aisin pumps.
 
Back
Top Bottom