Perhaps you did not understand.
"One could test without shocks attached, I suppose!. By capping all flex hoses. But you must have all 3 of the sensor wires housing blocks hooked-up to the 3 height sensors, to close the loop. Unless you know, of someway to jump those wire and get same resistance feedback to the AHC CPU."
I've never done these things, without the parts. You'd need to be creative to come up with ways.
All these lights, you've been concerned with. Have LED bulbs. Bulbs burn-out and are replaceable. Again, go to the parts diagrams.
FWIW: AHC Socks (hydraulic rams) are not pressurized, when out side of the system (not installed). Only Globes and accumulator are.
"One could test without shocks attached, I suppose!. By capping all flex hoses. But you must have all 3 of the sensor wires housing blocks hooked-up to the 3 height sensors, to close the loop. Unless you know, of someway to jump those wire and get same resistance feedback to the AHC CPU."
I've never done these things, without the parts. You'd need to be creative to come up with ways.
All these lights, you've been concerned with. Have LED bulbs. Bulbs burn-out and are replaceable. Again, go to the parts diagrams.
FWIW: AHC Socks (hydraulic rams) are not pressurized, when out side of the system (not installed). Only Globes and accumulator are.