TruSpeed Install - Behind Glovebox?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Nay

Joined
Aug 17, 2004
Threads
134
Messages
5,102
Location
Colorado
I'm installing a TruSpeed and was wondering about Superlift's instructions showing that the connection point is at the transmission (rather than the t-case sensor), and upon searching it looks like the common approach is tapping in behind the glovebox.

Is there a reason for this beyond keeping all of the wiring in-cab (which is understandably desirable)?
 
Also ease of access to switch back and forth between tyre sizes.
 
the reason I went behind the glove box was that I didn't want to break into an exposed factory harness out there in the elements. The glove box just happened to be where it was the easiest place to do it with a connector right there for easy identification of which wires needed to be used. That connector also has 12v and ground so there was no need to run power from another source. When done my truespeed was velcroed to the top of the heater box and has been there since 2000 with out any issues.
 
the reason I went behind the glove box was that I didn't want to break into an exposed factory harness out there in the elements. The glove box just happened to be where it was the easiest place to do it with a connector right there for easy identification of which wires needed to be used. That connector also has 12v and ground so there was no need to run power from another source. When done my truespeed was velcroed to the top of the heater box and has been there since 2000 with out any issues.

It makes good sense - I had just finished using a fuse tap for power and routing the lines under the truck, but I'm going to pull it and do the "glovebox install". Appreciate everybody's input.
 
Sadly my unit didn't work - I bought it from a mudder who had bought it for a GM application - we both called Superlift to confirm it would work, and we both got the same answer: "Yes, same unit". I'm guessing I got caught between the 2-wire/3-wire issue.

Just bought a 3-wire Yellow Box.
 
the initial offering from TrueSPeed had an issue with our cruisers. Mine worked intermittently and sonme didn't at all. They are the same unit as far as I know. How old was this one, Y2K maybe.

I'm not sure, maybe it was a bit older. It's frustrating they don't have at least a "power on" light to show proper power/ground, even though I'm able to test for power and the ground location I know is good. I took a lot of time soldering the connections the first time, and then broke those connections when it didn't work and used just a straight butt connector, then flipped the wires to see if that was a freak issue...nothing. Speedo on 0. :crybaby:

Seems everybody has good luck with the Yellow Box, so no bid deal. It will take very little time to install at this point.
 
Back
Top Bottom