Transfer Case Rebuild "kit"

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 24, 2016
Threads
19
Messages
188
Location
Greensboro, NC 27408
I have my transfer case mostly broken down and am now trying to find all the parts I need. Yes I tried a search first.

Cdan is not "in" right now (understandable) but I would like to get the transfer case rebuild in the next week or two. Does any one know of a parts list or a place where I can find all the parts I need? Since I have never done a rebuild on a transfer case, and although I have the FSM it would be so much easier to have a KIT with all the parts I need.

I also messed up one of the C clips trying to get it out so I will need one of those too.
KFzBST1.jpg
Wck5FyW.jpg
 
I just went through this, and I didn't replace all bearings, but here are the parts I did replace....

90363-40044 - BEARING, RADIAL BALL (FOR TRANSFER OUTPUT SHAFT FRONT)
90363-50005 - BEARING, RADIAL BALL (FOR TRANSFER OUTPUT SHAFT REAR)
90366-33002 - BEARING TAPERED (rear idler bearing)
90311-58008 - OUTPUT SHAFT SEAL
90311-50014 - DRIVE SHAFT SEAL

Everything else seemed to be in good working order, so I stopped there....Not sure on your 'lock ring' plier situation, but if it isn't up to snuff, these are the pliers I ordered, the "straight" one is the most helpful. Wilde Tool 9” Right Angle & Straight Lock Ring Plier Set Snap Retaining USA MADE
 
Thanks for all the quick responses so far it is appreciated.

I tried Beno, he is in Pa. for a bit and is not filling orders as far as I can tell. Maybe he will be back soon.
I checked Cruiseroutfit and am not sure is they have the kit for an FZJ80 or not. I have sent them an email to make sure.

Lazy: thanks for the tip in the snap ring pliers. Mine were not up to the task and I will be ordering the ones you sent me a link to. Thanks.
 
I checked Cruiseroutfit and am not sure is they have the kit for an FZJ80 or not. I have sent them an email to make sure..

Unfortunately not something we currently have but it is coming soon!
 
The most knowledgeable guy I know about 80 series transfer cases is Robbie Antonson, owner of Antonson's garage in Boulder, Colorado. His Mud tag is @powderpig. His Email is powderpig@q.com. He has rebuilt more 80 series transfer cases than anyone alive as far as I know. He did work for me on mine and did a great job.

@beno is also highly knowledgeable. He has rebuilt his share of 80 series transfer cases.

Either can probably send you a replacement transfer case and you can just mail yours in parts back to them. It will save you a lot of work and you'll know the job was done correctly.
 
curious what kit will include? all bearings, including needle bearings? seals? tapered bearings and races? dust guards? new studs? Will it also be offered as piece meal or a la carte?

Koyo bearings or some other manufacturer?

Just curious. I wouldn't ever wonder into a tcase again unless I knew there was a problem.
 
Is your T-case actually warn out? Or is this a preference rebuild? I have two units and both are at about 270k and operate like new.
 
The transfer case was okay except the rear seal was leaking. The real issue was that when removing the front drive shaft my helper destroyed the threads on the studs. Thats the main reason for the disassembly. To replace the studs on the front transfer case output shaft.
 
Check your bearings in the front and rear nose sections. Those are the items that get loose over time, especially when you change the angle with a lift.
 
Back
Top Bottom