Transfer case compatibility?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2006
Threads
116
Messages
672
Location
under Pike's Peak
The original transfer case in my 76 has cracked and I thought I would replace with a 3 speed case rather than try to repair the original. I found a transfer case from a 64 (that's getting back there, I know) but my knowledge has expired! The owner of the 64 case mentioned that it had a vacuum shift so that got me wondering about other compatibility issues. I don't understand the implications of trying to use this case. Can I use this case as is, or reuse my front output shaft cone, etc or what else haven't I thought about?

I know there is the conversion with the input gear etc. as I have experience putting a 4 speed transmission into a 72. Now I'm trying to go the other way.

Thanks for your help.
 
63-69 transfer cases are weaker than the 70-73 cases (not as many rib supports and an exposed drain plug. Internals should be inter-changable between these years.

No need to change nose cones, just use your front drive shift assy that bolts to the side of the nose cone, your linkage, front driveline flange and parking brake drum. But again, I would stay away from the pre-70 cases. Or if it's a good price, buy it and get a later 3spd case (which I have in stock).
 
HOW BAD IS THE CRACK ?

PICS WOULD BE GOOD ...

MINE HAD A CRACK AND WAS LEAKING, ON THE BOTTOM, I PUT A LITTLE WELD ON IT AND GOOD TO GO ... NO LEAKS NO WHERE .. ;)

GOOD LUCK ,,, :beer:
 
Maybe it's just me, but does it matter where the crack is? If it's cracked, you need a new case.

Good excuse for an Orion.

I would like to see pics though.:D
 
If it's a 76, you KNOW it's cracked in the typical place, from the inside rear corner of the top cover down around the idler boss. All the 76 thru 78 cases crack there eventually; that's their weak link.

If you catch the crack early enough on, a good TIG welder can take care of it for you. I've had several 76-78 cracked cases welded up by an FAA certified TIG guy in my neck of the woods. NONE of those cases ever failed again. Better than new.

One customer, many years ago, got nervous about the welding thing, decided to have me order a NOS housing from Toyota. I opened the box...................THERE WAS A FLAW IN THE CASTING FROM THE FACTORY ............IN THE EXACT LOCATION WHERE THEY CRACK!!!!!!!!!

I told the customer I wanted to get the brand new case welded from the inside before I installed it. He objected.

The case lasted just long enough to pass the warranty stage.:frown:

I will NEVER offer to purchase a new housing from Toyota for ANYONE again.
 
Mark,

That's where mine cracked. I've got JB Weld smeared on it now. Is that a "TIG weld in place kind of fix" or were all the repairs done outside of the vehicle?

If I can fix in place, I will consider that. Assuming that I have to remove the case, I would probably chage to an earlier case. Hence that question in the original post.
 
Back
Top Bottom