Tire pressure for MTR's

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 8, 2003
Threads
372
Messages
6,845
Location
Bozeman, MT
Howdy-

Strapped up my new 35" MTR's last week, and I LOVE THEM... so much I changed my signature!

Here is my question, I am now enjoying the benefits of a radial again, and was wondering what you guys are running your MTR's at.

I have started at 20psi on the street. What do you guys recommend. It feels really good right now, I just dont want to wear them out from running them at the wrong PSI.

Thanks in advance-

Rezarf <><
 
what does the tire say to run them at? good starting point, i run mine at 35 psi
 
Been running my 35" MTR's for over a year now at about 32lbs on the highway. I've been very good at rotating and balancing since I have a rear lunchbox locker but so far I have a very even wear pattern on the tires with that pressure.

troy
 
camcruiser13 said:
what does the tire say to run them at? good starting point, i run mine at 35 psi

What the sidewall says isn't really a good measure to deterimine the air pressure that is actually needed. There are too many variables such as weight and wheel width.

A way to check whether the tread is in full contact with the ground (and wearing evenly) would be to make sure they're warmed up (drive on them for a while) and then chalk (or paint) a stripe across the tread. Drive around for a while, and then check the stripe to check how the tire is wearing. Ideally, you'd want full contact with the tread while still maintaining the highest possible pressure to keep rolling resistance low. Adjust pressures as needed.
 
Back
Top Bottom