Thoughts on this 71

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 12, 2015
Threads
95
Messages
3,456
Location
Bakersfield, Ca
Want to know what the experts think. Anything unusual stick out?

Sounds like engine needs work.
Top looks kind of wonky in the back. Bent on the drivers side and is it separating on the passenger side?

This 1971 Toyota fj40 is ready for a restoration. Only a little rust in the rear corners. Replacement metal is easily obtained at Real Steel Cruiser Parts. The vehicle is complete with all the original seats and body is uncut. Dash is perfect, uncut. The original motor I think has a spun bearing, but the original drivetrain is all there. This rig is only for someone who wants an investment, to restore, perfect for father son project that will be worth a lot of money. Smog exempt in California. Clean title.

1.jpg
2.jpg
3.jpg
4.jpg
5.jpg
 
That seems like a lot for what you're getting.
 
Ya $6,500 which seems pricey to me. Maybe if it ran, maybe

That’s a good one to fix rust, bring to mechanically 100%, new vinyl, rebuild electrical, and leave in original paint. They are more fun when you can enjoy and use them without having to worry about.
 
That’s a good one to fix rust, bring to mechanically 100%, new vinyl, rebuild electrical, and leave in original paint. They are more fun when you can enjoy and use them without having to worry about.

Bringing it up par mechanically would be the main priority. Wouldn't really mess with much else but getting it driving reliability would be the big thing.

Going to call him after work and see what the deal is. It's local so could go check it out
 
Ya $6,500 which seems pricey to me. Maybe if it ran, maybe

Ten years ago I would have said 6,500.00 was quite a bit. Today with prices what they are, and scarcity, it really seems quite reasonable. Think about this, I saw an original new old stock FJ40 floor mat sell for close to 3,000.00.
 
Talked to the guy just now. Said engine turned over by hand when he originally got it but once he tried with the key/starter it wouldn't turn. Which seems weird to me?
So he suspects a spun bearing but doesn't know. I'm not an engine expert either so i'm not really sure

It's all there, seats, interior, bumperettes,
 
Last edited:
It looks like a good start. The paint will buff, no cut fenders and sounds like good interior. The motor if it’s bad will cost you or swap or look for a used runner. The roof looks like it has a sunroof cut in it. Just go with cash in hand and offer less. See if it works
 
A lot more value, including a four speed an an engine that runs in the ‘74 that @FeralOne is selling.
 
I'd have to see the floors in ALL areas to see if it was worth $6500 and I'm smack-dab in the rust belt. Once you climb and poke around the underbelly enough that "surface rust" can easily turn into panel replacement. I can already see you'll need to fire up the welder and stitch in some new metal on the DS rear sill.
 
Back
Top Bottom