This 80 a decent deal?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

At 380K assume everything is worn out.
Why did engine AND transmission go out?

I paid $5K for 1996 with 180K.
This one is a total crap shoot.
It might last but how much $$$ you going to pour into a truck with almost 400K?

I think there are better options out there if you want to Gamble.

At minimum with replaced Radiator do this:
block-test.webp
 
Wow! What a response! I'm not new to wheeling and dealing, just new to cruisers (other than admiring them). I don't know where you guys are claiming to find these deals. I've looked for a month now and I've found 2 categories of cruiser. 250k+ mile in *decent* shape (ALL the leather isn't destroyed, just the drivers seat, light surface rust underneath, and a couple rusty spots on the body) for $7,500+ FIRM (I've talked to every single one and none are willing to move on their prices); OR slightly less miles (150-250k) that are completely destroyed inside, and look like they've been sitting in the ocean for 20 years. They generally want ~$5,000, which is my budget.

I've also noticed, southern vehicles seem to be higher mileage, but better taken care of, while northern vehicles have less miles, but are more beat up, and less taken care of (typically, it's not a rule).

This one I can't really just hop over and check out either, it's 5 hours away. I'm going up there tomorrow though. If it's in as good condition as it seems I'll give him the $4,500 I offered him. If not, I'm just walking.

To be honest, the idea behind this vehicle is something that I will be DD'ing only for the next year (I'm selling my Jeep, and we are paying off all our debt this year). After that, this will become the vehicle that we will build up to travel all over the country, and eventually (hopefully) the world.

So, if the engine does blow up, as unfortunate as that will be, it will not be the end of the world for us (except a giant "I told you so moment").

One of the dreams I've always had is "building" my own car. I've modified plenty of vehicles, and done lots of stuff that most people wouldn't even attempt (4x4 conversions, engine/trans swaps, etc.), but I still have not completely taken a vehicle apart and reconditioned EVERYTHING, and put it back together. Yes, I'm sure I could buy a brand new cruiser for the expense of doing that, but it's something I'd love to do. To be honest, I'd love to actually "build" the entire thing myself, but that seems a bit of a challenge.

Thanks for all the advice, I'll make sure to check it out thoroughly before I lay down the money. I'm still on the look out for one of these crazy deals everyone seems to find though, and will jump on it if I see one lol..
 
I have a friend who recently made out like a bandit. He acquired an LX 450 1997, with 110 K miles, from original owner for $4000. From a doctor. Here in CA where everything is usually more expensive. Excellent cond. too. Right place at the right time.
 
Well, I brought her home Friday. Made the 5 hour trip with no problem. I got up there fully expecting to knock the price down to $4,000, but as I went to find things that didn't work (power antenna, sunroof, lockers, etc.) I couldn't find a single non functioning thing. It was actually in much better condition than it seemed from the ad.

Service records from 7k miles all the way to 375k. Apparently the original owner was an archaeologist and drove between Cincinnati, Alaska, and Mexico quite frequently. Then would drop it off at the local Toyota dealership and tell them to do whatever needed to be done.

I'm not sure if it's just Toyota build quality or because this thing has been serviced like it should be, but even with 380,000 miles, it doesn't have any vibrations, or squeaks or rattles or clunks or anything. Overall, I'm ecstatic about the results.

Now, first thing I'd like to do is CDL switch and 7 pin mod. Is there a best place to purchase the CDL switch? I see cruiserparts.net has it for $45. I'm going to try the junkyards around here today, but I don't expect to come up with anything.
 
Unless you want the "curved" switch you can pretty much use any hazard switch from a pick'n'pull with a slight trim for the CDL.
 
Of course, I have to be difficult and really would like the curved switch... If I find a hazard button today I'll pick it up, and be on the look out for the curved switch...
 
Of course, I have to be difficult and really would like the curved switch... If I find a hazard button today I'll pick it up, and be on the look out for the curved switch...
Don't blame you. I did the same. I don't remember what I paid for mine, but seemed spendy for what it is. Want to say maybe $25 on ebay. Remember that all US spec 91-92 came with the curved switch while looking (IIRC).
 
Well she looks nice good find, now get your wallet ready. And welcome to Mud
 
So, I've started getting her ready to go camping next month. Built a box in the back to store my junk and I can fold it out and sleep in the truck. No 91-92 Cruisers in any junkyard nearby, so I guess I'll just order the expensive CDL switch and do that and 7 pin this week.

Any recommendation on what I should do next? Tires and suspension will stay the same now. Probably only go with biggest size tire I can fit with no lift once these are wore out (several years before then).

Might get a set of Weathertech mats next. Really looking at a set of bumpers this summer. Might build my own (I am on a tight budget this year, until we get the rest of our debts paid off).

Ideas?
 
Nice!

-I like the steelies too, it's nice seeing an 80 not wearing the 16" alum wheels sometimes.

I know the guys who are more paint specific will say otherwise, but horseshoe & hand grenades, your paint is the same as buying a Sage 40th AE, and you got cloth & lockers.

You won man, looks like a great blank canvas to spec out as you like & use!
 
Back
Top Bottom