The Mysterious 'Stall' problem...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2006
Threads
21
Messages
62
Location
Southern Ontario
Some backgroud -- in the last month I have swapped my (78) Aisin carb out, sent it to FJJim in Ohio for a rebuild and replaced it. While the carb was away, I also replaced the gas tank, fuel lines, filters...all in anticipation of the rebuilt carb's return to the 2F engine in my 40.

I will be the first to say, the Cruiser has nver run better....but I do have a couple mysterious items. The SYMPTOMS:

First -- when I drive the Cruiser first thing, I need to apply some choke until the engine full warms - no problem. However, if I happen to get the engine to full operating temp, I cant ease off the choke without it stalling. Now if I get the engine to temp, the next time I drive it... whether its in 10 minutes or a couple of hours, it starts and runs well -- no choke required.

Second -- occassionally after the engine is warm and I have been driving for some time, I get the mystery stall. No ryhme nor reason, it just stalls out. Starts again no problem, but now I am forced to use the choke again.

I have discussed this at length with my mechanic, but no one seems to be able to identify whats happening.

Ideas ?? :confused:

Mark
 
Well, thats the thing....

For the most part, it runs well when warm. Idles well when warm. Why would the idle settings need to be changed if the engine runs well for an hour at a time, then mysteriously stalls ?

Not saying you're wrong by any means Pin - but my mechanic doesnt think its the idle settings.
 
Pin_Head said:
Cuz the idle might be marginal. If it is truly random check the idle fuel solenoid circuit for intermittent shorts, bad connections.
Without power to the fuel solenoid valve (FSV) the engine stops right away. If you let it idle and take the connector apart you will see what I mean. Take a voltmeter and turn the key on measure the voltage at the connector to ground on the carburetor. The next time it won't start leave the ignition on and check the voltage at the connector. If that wire is grounded some where along its path it will blow a fuse as it is not a ground wire.
 
Back
Top Bottom