TC Skid Plate...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

So its a real likelyhood that this will not be an option for skillet for some time now.... any idea from christo on a possible date for these other guys.



My guess is my install and Rubicon trail testing will need to be completed before the design will be finalized.

As I indicated earlier I believe there is one other plate in the field being tested right now.


Christo specificially asked me to high-center the truck as often as possible to test it....:eek:
 
Last edited:
most excellent dan, i trust you to not let us down. and on that note, the 80 is fully suspended in those pics by the skid, couldnt go foward cause no rubber down and had to be rocked off in reverse. so post up in comparison to BENO's day on the teeter totter video for the before/after comparisons.... cant wait to see this skid :bounce:
 
I had no problem at all with removing or greasing my front drive shaft with the plate in place.

Man-A-Fre carries the IPOR so shipping on the west coast shouldn't be that bad.

From so. cal to no cal, the shipping was about 130.00.....The shipping is bad!:rolleyes:
 
Hey Skillet-Did you get Slee's new skid????

Very curious what it covers and what it looks like.


No, I just got his standard skid plate.

Chatted with Dan about the new one and it is still under develpement. Sounds awesome though.

The standard will do me fine. $157 delivered is better for the old pocket book anyway.

Especially after my new gear job... :eek:
 
most excellent dan, i trust you to not let us down. and on that note, the 80 is fully suspended in those pics by the skid, couldnt go foward cause no rubber down and had to be rocked off in reverse. so post up in comparison to BENO's day on the teeter totter video for the before/after comparisons.... cant wait to see this skid :bounce:

Here's the video if anyone is interested.

I had the full weight of the rig on Christo's plate. Held up good. I did end up bending it into the xfer case. I re-bent the arm that holds it and the plate is still bent to all hell.

At CM08, I also got into another situation (ahem) where the entire truck was balancing on the Slee plate...again it did what it was meant to do--save the xfer even if it meant destroying the plate.

;)

Saw the proto when it came to work the other day. VERY LARGE PIECES OF METAL....really nice design though there are some things I am confused about. But this is a proto so no worries. It looks damn beefy to say the least!

YouTube - the 80 teeter
 
From so. cal to no cal, the shipping was about 130.00.....The shipping is bad!:rolleyes:

What?!

I had my IPOR skid shipped from their shop (VA?) to Seattle for $50.
 
My install is almost complete. It's in and I have to mark one more place that I need to trim and then pull it off, trim, and do the final checks. I have taken a few photos and I will ask Christo if it's OK to post them for you.
 
Last edited:
Back
Top Bottom