t-case lube?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 14, 2005
Threads
120
Messages
248
in the middle of rebuilding my t-case and was wondering what lube to use? I am going with an automatic tranny and all my previous vehicles used atf in the t-case but the cruiser had a heavier weight lube, but it was mated to a manual. What lube is recommended for assymbley? thanks
 
Hi All:

Make sure the seal between the auto tranny and the t-case is installed correctly!

Like "Poseur" said, a 75-90 weight gear oil is apporpiate for the transfer case.

Regards,

Alan
Seattle
 
Hey does the fill plug in the tanny also fill the transfer case? I drained my t case and tranny and refilled the tranny but could not get the fill plug out of the t case. Once I was finished filling the tranny I pulled the drain plug and it had the new gear oil coming out. Do they share fluid??
 
They do when the seal between them is fubared.
 
It will tend to suck the oil from the tranny to the transfer and (relatively) oil starve the transmission. Not too good.
 
If they are seperated via seal them why does sor sell this recirculating oil tube kit? Just another gimic to fix a 20 dollar seal or is it a legit kit?
 
IDave said:
It will tend to suck the oil from the tranny to the transfer and (relatively) oil starve the transmission. Not too good.

This is the case when the seal is fully failed.

When the seal has partially failed, it will allow fluid to migrate from t-case to tranny and overfill the tranny, leaving the t-case low. Also not good.

The return line kits are a lazy fix. Probably cost $30 vs. a seal that probably costs $5 from Toyota...
 
Same lube that goes in the diffs and transmission. Best to buy a 5 gallon pail of 80W-90 and a pump top from Northern Online and fill the easy way. You won't regret it.
 
Back
Top Bottom