Stumped. 96 Randomly Overflows While Fueling

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

This has happened to me too in my 96 two or three times. It seemed like the fuel leaked from under, but also from the area of the filler. It happened so fast that I wasn't paying attention to the details, just trying to stop the pump. Strangely enough if I stopped and started again, it worked again.

Everything is stock on my setup.

As a side note, I did notice that my oring on my fuel cap was cracked, time to replace.
 
The vapor/carbon canister has no role when filling the tank. Fuel flows in the fill tube, vapor out to the cap area in the vent tube.



Correct. Maybe I missed it, but was the fuel pouring out under the truck or from the cap hole?

Under the truck but seemed like up from the filler neck area, not at the tank itself.

I thought for some reason that the CC took the positive pressure from the displaced air/vapor while filling. It would make sense if they just came back up the vent tube. Wonder if my vent tube is partially obstructed or something like that.

I don't think there is a hole or leak anywhere due to the fact that I was getting pressure build up before i changed the CC, which would eliminate a hole somewhere, no?
 
Under the truck but seemed like up from the filler neck area, not at the tank itself.

I thought for some reason that the CC took the positive pressure from the displaced air/vapor while filling. It would make sense if they just came back up the vent tube. Wonder if my vent tube is partially obstructed or something like that.

I don't think there is a hole or leak anywhere due to the fact that I was getting pressure build up before i changed the CC, which would eliminate a hole somewhere, no?


If it's coming out under the truck, you either have a hole in your fill hose, a rusted out filler neck, a hole in your vent hose, or the gas is still pouring out the top and running down the little hole at the bottom of your fill door area with the weep hole at the bottom.

You need to get a MUCH better look at this.

If it's leaking near the center of the truck, about even with the rear door, then you have a cracked tank. And yes, it WILL still build pressure with a cracked tank.
 
If it's coming out under the truck, you either have a hole in your fill hose, a rusted out filler neck, a hole in your vent hose, or the gas is still pouring out the top and running down the little hole at the bottom of your fill door area with the weep hole at the bottom.

You need to get a MUCH better look at this.

If it's leaking near the center of the truck, about even with the rear door, then you have a cracked tank. And yes, it WILL still build pressure with a cracked tank.

Definitely not from center of the truck. I can see it drip down from the filler area, and seems like its from the neck somewhere.
I'll need to figure out how to get a look up in there. Couple of half blind photos i took after it happened. Seems to be coming from the top of the filler neck area.
 
1900237
1900238


1900239
 
Third pic, lower right. I see a straight line that the fuel follows on the fill hose. I think your fuel fill hose is cracked. Need to look for a replacement.

Item 14, 15 are the ones next to the tank.

I think what you ACTUALLY may need is item #9. (Toyota P/N 77201-60350)

NLA


Calling @slow95z and @arcteryx for used parts.

Also @mingles or @Marine7 I think had an issue with one of these that was rusted out.

Otherwise, there is NO reason fuel should be coming out down there.

1900351


1900355
 
I have parts and I am cheap. Thanks for the plug there @BILT4ME

Send me a message if you want to go the used route.
 
Was the vehicle running or off when fueling? I haven't had an issue with LCs fueling while they idle, but I've had work vehicles that will have a vacuum develop when idling during fueling, causing the same overflow issue. Just trying to clarify to help with troubleshooting
 
2 good EVAP youtube videos (Its more complex than most think)


1. Evap theory (not toyota but similar design)


2. Fast and dirty Toyota (not landcruiser) Evap system disection
 
Third pic, lower right. I see a straight line that the fuel follows on the fill hose. I think your fuel fill hose is cracked. Need to look for a replacement.

Item 14, 15 are the ones next to the tank.

I think what you ACTUALLY may need is item #9. (Toyota P/N 77201-60350)

NLA


Calling @slow95z and @arcteryx for used parts.

Also @mingles or @Marine7 I think had an issue with one of these that was rusted out.

Otherwise, there is NO reason fuel should be coming out down there.

View attachment 1900351

View attachment 1900355

Funny you mentioned me.... I’ve had NO problems with mine, but now, this week,I noticed it sounded like me fuel was “boiling”! Tank was near empty (which it NEVER is usually I keep at least 1/2 tank). So I believe I’m going to replace my charcoal canister, and/or do the mod which I believe (?) LCP posted awhile back. Not too worried about it,seems to be fairly common.
 
I think I was actually thinking of @Red Merle with this as the guy that was chasing down parts to replace the fuel inlet parts that rusted out.
 
I think I was actually thinking of @Red Merle with this as the guy that was chasing down parts to replace the fuel inlet parts that rusted out.

No problem, and I won’t even give you a hard time for “jinxing” me!:flipoff2: It’s all good though! Lol
 
No problem, and I won’t even give you a hard time for “jinxing” me!:flipoff2: It’s all good though! Lol

The Canister I used was the VC-120, but you have a 91, so I don't know if the valving is different. (Mines a 96)

Make sure you change it soon, because you don;t want to be part of the "Cracked Fuel Tank Club" like I am!
 
Third pic, lower right. I see a straight line that the fuel follows on the fill hose. I think your fuel fill hose is cracked. Need to look for a replacement.

Item 14, 15 are the ones next to the tank.

I think what you ACTUALLY may need is item #9. (Toyota P/N 77201-60350)

NLA


Calling @slow95z and @arcteryx for used parts.

Also @mingles or @Marine7 I think had an issue with one of these that was rusted out.

Otherwise, there is NO reason fuel should be coming out down there.

Thanks for the diagrams/ideas. It's been nuking snow in Seattle so haven't had a chance to try and get a better look at it.
I did however fill up again watching it at Costco and it filled to full, clicked off and had no leaks. However this was from 2/3 of a tank to full. I'm leaning to a crack in the filler neck or plugged vent. Hoping for the latter.

Your vent tube must be plugged.

Going to investigate that further. Wondering if some pumps are faster than others and with a partial blockage it may cause the overflow.

Was the vehicle running or off when fueling? I haven't had an issue with LCs fueling while they idle, but I've had work vehicles that will have a vacuum develop when idling during fueling, causing the same overflow issue. Just trying to clarify to help with troubleshooting

Always fuel with the vehicle off. Fueling while keeping a vehicle idling is just asking for problems!
 
I think I was actually thinking of @Red Merle with this as the guy that was chasing down parts to replace the fuel inlet parts that rusted out.


Yeah, I did mine.

Here is the thread.

 
I believe I have the same or a similar problem. If I lock the handle, after a few seconds the pump will click as if it is full. Sometimes I will see fuel come out high from the neck...but if i lift the gas nozzle up about half an inch, I can finish filling up without a problem.
 
Thanks for the diagrams/ideas. It's been nuking snow in Seattle so haven't had a chance to try and get a better look at it.
I did however fill up again watching it at Costco and it filled to full, clicked off and had no leaks. However this was from 2/3 of a tank to full. I'm leaning to a crack in the filler neck or plugged vent. Hoping for the latter.



Going to investigate that further. Wondering if some pumps are faster than others and with a partial blockage it may cause the overflow.



Always fuel with the vehicle off. Fueling while keeping a vehicle idling is just asking for problems!

If you remove the inner fender liner on the driver side, you can see the system a little better. Just takes 10mm socket and I think three screw heads for this operation.

i agree with others, the charcoal canister has no role while you're filling up. It's purpose is to suck the fuel vapor out of your tank while your engine is operating. The VSV under the intake opens up when the ECU says so and the vapor gets sucked into the intake, thereby reducing vapor being built up in the fuel tank.

While you're filling up, the extra vapor displaced by the incoming fuel leaves the tank using a small vapor return pipe back up to the filler neck then up the fuel station's filling nozzle. That's why they all say "do not top off", otherwise, the vapor return will not work as well and you make a mess on the ground.

I'm curious to see the issue turns out to be.
 
Any resolution for this old thread, this exact same thing just started on mine, California truck no rust, have had the pressure build up but was reduced significantly with a vc120 charcoal cannister. The last 2 fill ups turned back after shut off noticed fuel on the ground. Seemed to be from venting, not a hole or crack in the tube. Maybe Ill try fishing down the vent with a wire or ? to see if there is a clog in the vent. Was also thinking about servicing the fuel pump and filter soon as preventative maintenance since the fuel gage seems very slow to react after a fill up, thinking may be varnish or corrosion preventing free movement of the float.
 
Back
Top Bottom