Speedometer still not working after replacing vss?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Just did this. My speedo was working intermittently. Took about 8 hours to trace and run a new wire to the VSS.

8X$85 shop rate... Luckily he is on my payroll.
 
There is a ground wire that attaches to the back of the upper intake manifold. It's labelled as ground point "EC". Make sure the bolt for this is still attached to the back side of the upper intake (between firewall and intake). Mine gave me issues until I reconnected the ground.
 
I got in the truck and the speedometer would not work was working the night before. Noticed od light flashing so searched forum and seemed that the vss was probably the culprit replaced vss no od light blinking but still no speedometer whoops I guess I needed to drive it longer the od light is still flashing
 
Last edited:
What code did it flash? Check your ground at the transmission dip stick and the harness that goes under the manifold above the starter. If all that is good then it's probably the sensor in the speedo.
 
Could not find the wire break as it was intermittent. The speedo would work and drop to zero suddenly with no warning and started working again. After tracing each junction points multiple times, it was finally determined to be that the wire was damaged... Like I said, 8 hours labor for wire trace. Luckily I own my own shop and we specialize in this kind of repair.
 
Anyone have a photo of this ground? I just searched the back of the I take manifold for 10 minutes and couldn't find this ground. Found one on the manifold that faces the driver fender, but nothing specifically between the manifold and the firewall
 
Anyone have a photo of this ground?


To the left of the circle wrapped in a protective sleeve

hose_2.jpg
 
I had the same problem on one of my trucks. Replaced sensor with the sensor on my other truck and verified it was not the sensor. Found a used guage cluster swapped it in bingo speedometer works. Sometimes the cluster goes bad.
 
Thanks guys. I've swapped 3 sensors and even a different gear assembly. Ground on manifold is on there solid. Guess I'm lookin for a new cluster
 
It seems when the speedo goes bad most people find a burnt circuit on the back. It looks like you could've roasted marshmallows on the back of my speedo when it went out. I bought a used cluster and it's all good now.
20160314_124540.webp
 
Back
Top Bottom