Semi float axle upgrade

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 20, 2017
Threads
12
Messages
178
Location
dixon, california
I have been looking and turning over every rock I can find. I have a semi float that I have already re-geared to 4.88s and rebuilt from end to end. I’m not really interested in swapping to a full float because I don’t want to rebuild it again. Is there anyone out there that makes upgraded shafts for the semi float under my 80?
 
FF rear is one of THE reasons to own an 80. Rear discs are a bonus, but you need to change the e-brake cable ($70). Should be able to find an un-locked rear for the same price as chromo axles - if you can find them - and it'll be a much better set-up longterm.
 
Last edited:
Yes you are correct but I don’t want rebuild a new axle.
 
Rebuilding a rear FF axle is one of the easiest things to do, but if you want chromo rear shafts for a SF I would get with nitro gear and they probably already have the measurements. Or you can take yours out to measure and realize that taking a rear shaft out of a SF is a pain in the ass which is why everyone wants a FF
 
sounds like y’all are probably right. Probably gonna slap a spartan locker in it for this summer and then find a non locked full float. Sucks because I already bought a nice set of 15 wheels I was getting ready to throw on. Have y’all ever heard of anyone breaking the SF shafts?
 
It's not like the SF axles are weak, just weaker than the FF ones. If you're running the 33's listed in your sig, I would just leave well enough alone. There are lots of 60 series out there running semi-float axles and larger tires with no worries.
 
I have actually went to a dobinsons 4 inch and 35s. I won’t be going any bigger though. I’m also dropping weight too. Got rid of my giant slew dual swing out. Also lightened up the rear with my gear too. Once I get my trailer in order it will be near factory weight again.
 
Common failure of SF is not shaft breaking, but the C clip fails and all the wheels with the shaft are pulled away from the axle.
This is more likely to happen with bigger tires I had some pictures of catastrophic failure like this

I just bolted on FF open diff rear axle from 1996 rig (400$) (you need all braking components including hand brake cable)

You get FF plus disk brakes

Anyway, there are a kit or al least there was a kit for the conversation

 
That sounds like a bad time. I will keep this in mind. I will also keep my eye out for an axle.
 
Back
Top Bottom