scanguage II problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 7, 2007
Threads
83
Messages
500
Location
Raccoon City
Website
www.coopxgear.com
ok, its a been a while since i've been on here but just returned from another trip for uncle sam, so i go and start the cruiser, and for some reason the ScanGuage II is lighting up but the display is blank, nothing there, no text or nothin. any idea what the problem is? and how do i fix it?
 
ok, its a been a while since i've been on here but just returned from another trip for uncle sam, so i go and start the cruiser, and for some reason the ScanGuage II is lighting up but the display is blank, nothing there, no text or nothin. any idea what the problem is? and how do i fix it?

I've had that happen once, since I got mine about a month ago, next start it worked fine. (It hadn't been sitting a for a while though, I drive it every day or so)
 
My ScanGaugeII did that once after leaving for a week in 90+F temps. Just pushed button after second start attempt and it work fine afterwards. If that doesn't work try removing and reinserting the ODB-II plug. Hope that helps & WELCOME HOME! THANKS FOR YOUR SERVICE!
 
I think S.Carolina mentions a good point. I had an issue with my screen only showing 2 out of 4 readings. I sent it in and they repaired it for me. However, this was in the winter and I hadn't used it in any heat or freezing temps yet. Since I got it back I take care to make sure the screen is kept out of direct sunlight by placing a cover over it and using windscreen sun shades to help keep the heat down. The unit seems fairly fragile compared to a car stereo etc, so I'm just trying to be cautious so I don't have to send it in because my warranty is almost over.
 
Mine did it too from sitting for awhile and dead batteries. If you take out a battery and hold the power button for 5-10 seconds, replace the battery and power on, it should come up. Worked for me, let us know if it works for you.:wrench:
 
well, it hasnt come back on and i've driven the cruiser a few times, i'll try to unplug it and see if that works, i dont know what the weather was like while i was gone but cant imagine it got too hot, its the bay area of cali, although the batteries were fairly dead when i got home. just enough juice to get her started. whats the repair service like with scanguage? i dont really want to have to buy another one, as im just about where i need to be in the cruiser fund for my rear bumper.
 
The same happened to me last week when I carelessly left the drive side door unshut for a couple of days. (Got to do the LED mod). Jumped the car up, but lost the scangauge display. Reconnecting the jack behind the gauge seems fix the problem. Good luck.
 
Last edited:
unplugged it and that worked, thanks guys
 
Back
Top Bottom