rollcage

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

It would apprea that they hang quite low but that is partly because I cut the rear panels up so high when getting out the rust. They are at the same height as the frame. Sitting a little over 21" off the ground with a flat tire and 31" tires
 
Finally got back to work on it today after a long delay. Heres a pic of the tire carrier up on top of the rear cage. I'm pretty much done now just doing some superficial stuff now like final capping on open ends and thing of that nature. Can't wait for my carb to finish being rebuilt. I'll get a nice outside full pig shot asap.

Edit: Must have forgot it last night its there now.
 
Last edited:
Last bit of finish work is done, so for now the cage is officially done. :bounce:
 
Last edited:
Here are the long awaited pics of the full cruiser outside which I was lazy and never took off my camera.
 
Last edited:

Users who are viewing this thread

Back
Top Bottom