Replacing tie-rod ends

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 8, 2011
Threads
294
Messages
1,669
Location
Toronto, NSW, Australia
Received my lovely Witsend bushing press tool set during the week - what a great product!

While I know the front panhard bushes (at least one of them) is shot, I was wondering about the tie-rod ends. I've got a set of 555's (ironically removed from my 80 when I had a shop trying to figure out suspension and steering issues) which were about 1 year old at the time. Currently I've got el-cheapo ones and suspect they're wearing. I've checked (a few times) the removed set of 555's and they appear to be fine. A$77 for a set of cheapo ones was ok at the time. ;-)

To change them, it theoretically should be an easy job. To get the toe setting close enough to drive to a shop to have it re-set after fitting new tie-rod ends, I'm presuming a rule-of-thumb is to measure (as accurately as possible) to spacing of the current ones on the rear rod and try to match that as close as empirically possible.
 
Alot of installers just count the number of turns it takes to remove the old tie rod end, and then install the new one the same number of turns. Installing your new tie rod ends this way will get you in the ballpark for your drive to the alignment shop.
 
Removing tie rod ends can be an absolute prick of a job, don't count on it being easy.
If they were changed recently it should help.

I measure the tie rod from centre of each tie rod end, it will get you pretty close.

Setting toe in is easy enough to do yourself without taking it to a shop
 
I agree with counting turns. IF the truck is on the ground and you don't move the tires then you should be able to count the number of turns on each end and then put it back on truck. Should line up to almost same as before. Easily able to drive it to shop.
 
I just installed a set of 555's on my 80, replacing originals from my 92 HDJ81. They were seized in pretty good. I just counted the number of threads exposed on each side. What others have suggested works too. As long as you dont move your wheels, if they drop back in you should be fine. I drove a few hours from work (where I did the re and re) to home where the shop was doing my alignment without any issues.
 
Most likely the old ones will be extremely difficult to get out. PB blaster on the slot will help a lot. But, there will probably still be rust and crap in the threads. I used my old TRE and cut a slot in the threads with an angle grinder, then cleaned those thread edges up with a small file. Then used the old now-slotted TRE to chase the threads in the relay rod before putting anti-seize on the new TRE for final install.
 
First, what is wrong with the ones on the truck, do they have play? When installing ends, always be generous with the anti-seize, makes future adjustments much easier. Setting up toe and steering wheel center is pretty easy and a home job is likely to be better than most alignment shops will do.

Alignment Setting Toe
 
Counting turns is usually a good method to get new rod ends close to where the previous ones were positioned. But, that is making the assumption that ALL brands of TRE's have exactly the the same number of threads on that end of them. I have no evidence either way, but we always double check to make sure that there is the correct amount of toe in from tie rod adjustment.
 
Not sure what the OEM maker is, but 555's are a high quality brand a bit like HDK is a high quality aftermarket brand of CV joints when OEM (NTN made) are not available.
 
Back
Top Bottom