Rear Heater Lines

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Any reason not to just pull the original pipes and run soft lines all the way back? Maybe the exhaust heat would be too much for rubber?

I was thinking you could fasten everything up with hose clamps or something to the original mounts, maybe tack weld in some new ones as needed? I've never been face to face with that area myself, just thinking out loud.
 
Maybe @NLXTACY should team up with @69LC and win. Win. Win.

Definitely, anyone with the skills and time. I've brainstormed the idea of few times, maybe starting with 4-ply industrial heater hose (Gates), re-using the original brackets cut off the old pipes, etc,etc. but don't have the time or skills to do it right. On my 96 FZJ80 I closed off the rear heater pipes under the vehicle due to corrosion to prevent a leak, but would like to bring the rear heater back to life. Seems there should be a reasonable market for a replacement set of hoses/pipes for those who need the rear/extra heat.
 
My goal is to develop a “simple” bolt on kit with stainless lines that will not require removing the original lines in the tranny hump. I found hoses at my local NAPA that easily allowed the reroute.

My wife’s 95 is still waiting to be ready-reassembled from a severe overheat that cooked the engine while our then 16-yr old daughter was driving and the steel lines blew out.
 
Making progress. I was able to make a body cut to build my fixture from. Stay tuned!

Of course this truck needed better lines too.

8718218C-DDC3-42F7-B665-E2D70B3FF63A.webp


2B4F65D8-0E9B-4674-8879-26D6DEE45608.webp


ABDD0A7C-F90B-4F02-87F0-360FF4AA09D0.webp
 
This thread shows why I’m going outside of just finishing fixing my wife’s truck and developing better rear heater lines for everyone.

 
I hope to get back to it soon. I stepped away from my civilian job and home for a minute to dust off my old Crew Cheif job duties flying around the county.
Awesome!
 
Following this closely. This is a common issue in 3rd gen 4Runners, but Toyota got smart for the 2001 model year and went stainless for those lines. Superseded the original part number so that replacements are only stainless as well.
 
My rear heater lines crapped out as well after running some rust remover in the coolant for a flush. Now I'm in the dilemma of whether to just by pass it or try to find a fix for it. Is it possible to replace the line without pulling the motor?
 
Is it possible to replace the line without pulling the motor?


anything is possible with enough time and beer or money. unless your in a really cold climate i would just by pass it and call ti a day. when you do the by pass i would also replace the heater hoses on the firewall and heater control valve
 
Back
Top Bottom