Rear driveshaft problem.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Trollhole

THC
Supporting Vendor
Moderator
Joined
Mar 6, 2005
Threads
1,565
Messages
21,212
Location
Mauldin, SC
Website
forum.ih8mud.com
I noticed a vibration ever since I went wheelin a few weeks ago. I thought it was the rear output shaft hi gear that was going bad but upon a closer inspection of my rear drive shaft there is side to side play in the yoke. I think this is my problem. So now I need to get it replaced.

My delemia is I have Hyper shackles in the back that allow for fairly long articulation. I havea felling the PO who installed the driveshaft didn't know what they were doing because I think the reason the yoke is shot is because the driveshaft is to short. Look at this pic and see what you think. Stock springs SOA. What do you think I should do? And whats a cost effective way of fixing this? Or is this even look short to you?

IMG_2806.JPG
 
Ya, you shouldn't be able to see the splines. You either have to get it lengthened or you could get a spacer made. Is it in phase? That could give you a vibe.
 
Phase.. Meaning, making sure your unjoints are lined up front and rear on a 40series (some have a mark), or like my 80 series, 90 degrees on the front and lined up on the rear....
 
I run a CV joint in the back, but it looks like to me... I could be blind... your drive shaft is bent. Not sure though. It looks like where it drops in size and then opens back up to mount to the outer tube.
Driveshaft.webp
 
just find a front driveshatf and get it cut down to size so that you cant see the splines. and keep yours as a spare
 
You don't have enough spline engaged. It is sagging because the spline that is engaged doesn't have enough surface area. Pull the shaft and look at the wear pattern on the splines and how much is engaged. Should be a couple inches, not one inch. Plain and simple, longer shaft or spacer. If you have a friend or parts guy with lots of spare shafts around, you may be able to find one that fits. Just don't get one with a 3 speed flange, smaller bolts and pattern.
 
I would s*** can that and get a new shaft. since yours is damaged, and too short, The SOA may have caused some of this as well. I have a front drive shaft from a 68 Fj 40. Sitting in the barn. would need to have the flanges changed to fit the 4 speed but you can have it for a cheap 6 pack and shipping.

Let me know I can get it boxed this weekend.

Warren.
 
Back
Top Bottom