- Joined
- Oct 16, 2007
- Threads
- 47
- Messages
- 198
does anyone know were i can get new rear ambulance door hinges that are stainless steal? i have seen fron door hinges stainless and hood hinges but no ambulance door hinges stainless.
rear ambulance door hinges?
- Thread starter bulldog11267mad
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I do not thnk anyone carries rear SS door hinges. You can rebuild them assuming they just need new bushings. Here is a photo of mine. I groud the head of the pin down but not off. I then drilled the pin shaft so I could drive the pin out. I had the parts sandblasted and powdercoated. The rear hinges use the same nylon bushings as the front hinges and you can get them from SOR, Man-A-Fre, etc. I bought SS socket head bolts and nylock nuts from McMaster-Carr. The bolts did not neet to be altered in length. I also posted a picture of the fron hinge for comparison.
I do not think it would work, but I could be wrong. The part of the SS pin that locks the pin in the front hinge would lock the outer hinge half and the bushing. I do not know if there is enough material on the outer portion of the rear hinge to keep the pin locked in place, thus I used a bolt, 2 flat washers and a nylock nut - all SS. I will order some pins and see how well they work.
The part of the SS pin that locks the pin in the front hinge would lock the outer hinge half and the bushing. I do not know if there is enough material on the outer portion of the rear hinge to keep the pin locked in place
AHHHHHHHHHH
AHHHHHHHHHH
- Joined
- Oct 16, 2007
- Threads
- 47
- Messages
- 198
- Thread starter
- #6
the hinges are ok but i wanted to put stainless hinges on so i never have to worry about rust. but if they don't make them then ill just clean them up. they don't really have rust on them and the work ok i just wanted stainless.