Real time help... what did I break?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 9, 2009
Threads
148
Messages
840
Location
Mason, Texas
Website
www.irontonforge.com
Please help me diagnose what broke. While at a red light I saw smoke, pulled over, opened the hood, didn't see anything out of the ordinary.

Short time later, had a bad vibration from front drivers side wheel. Then the brakes got mushy and steering pulled to the left badly. Limped it home and the wheel is too hot to touch! Lots of smoke!

I rebuilt the knuckles about 15k ago... I'll take it apart later this evening. What caused this? What parts should I order.

20170419_122003.webp
 
Wheel bearings loosened up or caliper seized?
 
If the brakes got mushy, I'd suspect brake issue? I bet the calliper seized, ground the pad down to nothing, then it slipped right out. At which point you started grinding the calliper piston itself, until you hit the seal, squirting brake fluid onto the very not rotor, producing smoke.

A.
 
Did one of the caliper bolts fall out?
 
Did you confirm? If I'm correct in my guess, your brake fluid should be low.

Since everything got so hot... should I replace the bearings to, while I have the wheel off?

If the wheel doesn't move in the vertical axis, the bearings are likely OK. I would repack them, since you're most of the way into it.

A.
 
Did you confirm? If I'm correct in my guess, your brake fluid should be low.



If the wheel doesn't move in the vertical axis, the bearings are likely OK. I would repack them, since you're most of the way into it.

A.
Its hard to tell from the picture. But the bottom of the wheel/tire slants out quite a bit. I'm guessing 2 inches.
 
Not sure yet. Darn thing is still too hot to work on. It discolored my nice steelie. :frown:

What, no pics? Come on, come on, chop chop .
 
Same thing happened to me last year. Wheel bearing was super dry, and grenaded.. it destroyed the spindle, rotor, and pads.

Caliper was fine tho, and still in use today. Think I paid $80 for the spindle, but can't remember where I got it.
 
I'm asking so I can order the parts now. I can't tear it down until tonight.
OK, what parts are you going to order if you don't know what parts you need yet?
 
What caused this? What parts should I order.

OK, what parts are you going to order if you don't know what parts you need yet?

What @jonheld is trying to say is that if you're not entirely sure whats broken and what caused the failure, knowing what needs to be replaced is impossible. Even with the collective knowledge and experience here- and I'm sure dozens of members could start rattling off part numbers, what you're asking is indeterminable until you're into it. Ordering parts ASAP to reduce wrenching time is a luxury, and unfortunately it seems that you'll have to do without that luxury this time.
 
Since you won't take it apart and look at it.

Order the following:
2 Knuckles
4 Thrust Bearings
2 Rotors
1 Short Axle Shaft
1 Long Axle Shaft
2 Loaded Calipers and bolts
2 New Tires
1 Axle Rebuild Kit

Life Flight can deliver the parts for $10K

If that doesn't max your card out. I have a Running Cruiser ready to deliver tonight.

Don't ever let money hold you up!
 
Back
Top Bottom