Re Route Heater Hoses

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

My Cheap Heater Valve solution

The valve on the block is stuck on "permanently heating" mode, so I put an inline ball valve just under the dash. I cut the handle down and soldered pieces of 1/2" copper pipe on either end, including an elbow. Now I can decide in flight whether to heat or not to heat. Total cost was about $12. ;)
heater valve close up.webp
heater valve.webp
 
you can take out the hose connections and put pipe plugs in there and it will not affect anything the heater lines do not affect engine cooling .i have a 65 that came from the factory that way good luck
 
Last night I pulled the heater and hoses out of the cab. Under the hood I cut one hose and looped it back to the waterpump. I'll reinstall at some point but I'm gonna be working on wiring for a while and just figured I might as well pull it all outta there.

This is on a SBC by the way.
 
I have a 1966 Toyota Land Cruiser FJ40 with a heater, but did not have the hot water shut-off valve at the firewall. I purchased 1 from SOR. Now I need to determine how to install it. This is a great picture of how the valve mounts on the firewall. Could somebody please get a picture of where the switch mounts on the dash? I may have to drill a hole, and only want to do this once.
 
Thanks D' Animal for the picture. I have a 1966 Toyota Land Cruiser FJ40 with a heater unit. There was no shut-off valve at the firewall, thus the great picture is very informational to me. I purchased a SOR hot water shut-off valve, thus this picture is useful to me. Would you be willing to show a picture of the dash where the hot water valve switch is? I am looking for a picture from the driver's seat, not under the hood this time.
 
Back
Top Bottom