Rams Horns Gasket

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

For the gasket to the head, some don't use any..I was never that lucky. I use the metalic 3-piece set with a light coat of high temp silicone on each side. For the donut gasket, Felpro makes a nice metalic one, the cheap fiber or whatever last about a month.
 
So, you say I don't even need to use one? If it's a better idea to use one couldn't I just use a standard SBC gasket?

No, I'm saying some people don't use one but I haven't been able to seal it that way. i have had to use gaskets and here's how I did it. Use whatever gasket that fits, one/three piece, cork, fiber, copper whatever. Some materials will outlast others. That's all I was saying.
 
I have used copper in a one piece design and I find it works well. Just have to remember to re-torque after you run it a while .You can use square , oval or round depending on the heads and the manifolds themselves .Take the manifold with you to the parts place and find the one that matches best.
 
GM doesn't use exhaust manifold gaskets on most, if not all of their engines. Gaskets can be used. If it were me i'd assemble w/o them and see if they leak. If they do, then use gaskets or do it right and have the manifold surfaces machined true so they seal correctly. Never take off an exh. manifold when warm or hot, they will warp when they cool and then leak. FYI
 
Header Gaskets

Just go to Auto zone or Napa and get some one piece header gaskets. They will last along time with exhaust manifolds.

JR
 
Rams horn gasket

I've had rams horns on my V8 for 3-4 years.........use Permatex rtv silicone gasket maker hi-temp red sealant, works lika charm.
 
Back
Top Bottom