Preload

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 23, 2005
Threads
201
Messages
594
Location
SoCal
Can someone explain to me the meaning of "preload," where it comes into play and how to do it? If this is asking for too much detail to include in a reply perhaps a point to a link that would clue me in?
Thanks, y'all.
Vic
Redlands, CA.
 
Preload is a quantity applied to tapered roller bearings that describes how tight the rollers are in the races. It is usually measured as a torque value for turning the bearings in inch-pounds. Too little preload or to much preload decreases the bearing load capapcity and lifetime.
 
The most common reason why bolted joints fail is due to the bolt failing to provide sufficient preload to prevent the external applied forces overcoming the clamp force acting between the joint faces. Image 1 presented below illustrates the joint decompression point. This is when the clamp force acting between the joint faces, that has been provided by the bolt's preload (the torque on the threaded fastener), has been reduced to zero by the applied forces. Once the joint faces have separated the bolt will be subjected to bending forces and the joint faces to fretting. This will lead to a loss of preload and the bolt subsequently failing by fatigue or other mechanism. This way the decompression point is taken as a design failure criterion. The importance of having a high preload can be illustrated by using the decompression point. Image 2 below illustrates this point: As can be seen that a higher preload raises the decompression point. For this reason it is better to tighten a fastener up to close to its limit rather than only partially tightening it.
decompressionslide.gif
decom2.gif
 
Back
Top Bottom