Power steering pump replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 10, 2014
Threads
11
Messages
282
Location
Houston Area
So I finally busted out the wrenches to replace my groaning power steer pump. And I can't see how you disconnect one of the lines before removal. Here's a pic

ImageUploadedByIH8MUD Forum1425150590.273046.webp


You can see how I have one off already, but I tried to unbolt the other line but all it does is rotate. The FSM shows something a little different.
 
In the second picture, the large hose that comes up from the bottom of the picture. Trace that to the pump.

EDIT: The union bolt that connects the pump to the pressure feed tube. Any tips for how to get this bolt out without messing up the feed tube?
 
Last edited:
I don't have access to air tools at the moment. It appears the union bolt is stuck to the feed tube. I hit it with liquid wretch, but can I rotate it until it gets stopped by the engine block and keep turning? I just don't want to break the tube.
 
More bad news. Feed tube is toast. I kept wrenching on it and it kinked up. New one from the dealership is a $300 special order part. Any suggestions or do I have to bend over on this one?
 
I think Napa carries one for less. Think that is what my buddy did IIRC. Search here too, seems there are some alternatives. Mine was PITA to remove as well, but eventually got the job done with harming it.
 
http://www.napaonline.com/Catalog/C...ing-Pressure-Hose-OEM/_/R-PSK72928_0371889746

Replaced mine 2 weeks ago. There is a "bolt"/bushing that threads into the pump below the banjo fitting on the hose. You need to have a wrench on the bushing to hold it against loosening when you remove the main bolt that goes through the hose.

That explains why loosening this bolt has been such a pain. I just ordered the O'reilly's version of it for 50 bucks. The dealership can suck it. I'm taking a break from working on it. I'm too pissed off.
 
I got it off. I ended up having to unbolt the pump. Once I had it dangling under the truck where I could get a grip on it, it didn't take long. I didn't have a 24mm, so I used a crescent wrench and a 3/8" drive with cheater bars on both and broke it loose. Wow, that sucked. Now I just have to replace the line. Thank you everyone for the help. I also need to reuse the gear for the new pump.

The FSM says I need a special part:

Using SST, press out the gear. SST09527−10011

Anybody know what part this is?
 
Sure
ImageUploadedByIH8MUD Forum1425167114.414177.webp


You can see how it's kinked, even after I tried to straighten it out. I can get you a better picture when I get it off the truck.

Thanks for the link. It really helped.
 
Counter Clock Wise. I did the same thing when I first got mine - the first O'riley hose developed a pin hole after 2 years. I was mad and thought I should get OEM but since it was still warranty, just swapped it out - the new one was much better - very nice quality
 
Back
Top Bottom