Phillips DRL install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

musthave

All maps, one app!
Supporting Vendor
SILVER Star
Joined
Sep 4, 2013
Threads
729
Messages
5,910
Location
Florida / Colorado
Picked up the Phillips drl's. Installed with wild yoats brackets in my brand new ARB.

But...

They stay lit for 5 seconds and then turn off.

I wired black to ground. Then installed a switch. Red to switch, black to ground and white to the red of DRL box.

The brown from DRL isn't connected to anything.

Switch is illuminated and when in on position the led's light for 5 seconds then turn off. If I turn switch off nothing. Back on and they're good for 5 seconds.

Anybody install these wired with switch ?
 
1. did you test them connecting the module directly to the battery .?

2. IIRC instructions said they need at least sense 13.8 to stay on ..
 
Yes, but I think it's the voltage sensing that they do. I run odyssey marine gel and this seems to be an issue. Calling them tomorrow unless someone else has experienced this.
 
Try leaving your switch on, then start the truck. They should stay on until you kill the engine (or shut off your switch). I think they look for the voltage to drop when the engine shuts off, and a voltage increase when the engine (alternator charging) starts. If you put a switch in there, it never sees the "hey, turn on" voltage jump. Try it. I played with mine quite a bit with a benchtop power supply before I installed them.
 
Try leaving your switch on, then start the truck. They should stay on until you kill the engine (or shut off your switch). I think they look for the voltage to drop when the engine shuts off, and a voltage increase when the engine (alternator charging) starts. If you put a switch in there, it never sees the "hey, turn on" voltage jump. Try it. I played with mine quite a bit with a benchtop power supply before I installed them.

That's how I run mine. On all the time. Only throw the kill switch when it's hooker and blow time.
 
IIRC, there was a thread were someone listed a Phillips customer support number that you could call. In some cases they would send out an older control module that was programed slightly differently. Might be worth a call to see if the other controller would allow you to run this setup how you originally planned.
 
Fixed it. Yea, no need for a switch. I was testing with truck off. Works perfect now.
 
ImageUploadedByIH8MUD Forum1451591878.621833.webp


ImageUploadedByIH8MUD Forum1451591889.286800.webp
 
These are interesting toys. Since they're 6000K, do they look white vs the halogen yellowish headlights at night time? I might put them on other vehicles too, can't be too safe!
 
No dim, they're bright but not as much as high beam. I leave them on whenever driving now. They don't look white, but whiter than lowbeam.
 
Back
Top Bottom