Pertronix 1662ls no spark

[jraj]

This is amazing and so thankful for the responses. I have the red wire the ignition and what I believe is the fuel cutoff (green connector) on the positive side of the coil. I removed the resistor when I went to the flame thrower 3ohm coil. I assumed that resistance was in the wire and the ignition circuit but maybe that’s too much. The poor method of attachment of the red wire is temp. As I abandoned the original red wire and ran on direct for testing.

View attachment 3783177

View attachment 3783178

On a sidenote, trying to see how I can get a hold of one of these for my dizzy. What is this and where can I buy a replacement one?

 

[JohnnyC]

@jraj A ground connector between the breaker plate and case on the Chinese electronic ignition distributor

its just a wire with two ring ends... just make one but give some slack as the plate moves to advance timing

or... look up breaker plate distributor ground strap .... most should work