Original PHH?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

mdawg

SILVER Star
Joined
Jun 13, 2014
Threads
13
Messages
161
Location
The Colony, TX
Hi, all,

A couple of weeks ago my upper radiator hose burst, which prompted me to take a closer inspection of all my coolant hoses, obviously including the PHH. Does this appear to be the original PHH (pic below)? I am guessing so, based on the style of the clamps.

If so, what do you think is the urgency to replace? With 253K on the odometer and another coolant hose bursting, I would think it would move to the top of the priority list. Then again, the exterior of the hose looks okay. I've got pretty bad oil leaks that I am wanting to fix first (front crank, oil pump, oil pan), but am thinking that overheating a 1FZ-FE is much worse than adding oil every 300 miles.

Thoughts?

IMG_1531.webp
 
If you don't know. Do it ASAP. Better a crappy day in the garage than a night failure 50 miles from home.
 
That's the original. I'd change it now. As an aside, the area around it is quite clean.
 
I just did mine with a 195k on it and it was still original and it "looked ok" from the outside and not much different than yours. The thing was a hard as a rock when I finally got it off, razor knife would hardly bite it to it. It was also still original so I replaced it with some blue high temp Silicon hose and some fancy constant tension hose clamps, I had to use a BIG crow bar to get enough lift on the hard pipe and forward push at the same time to get it line up enough to slide back on.
 
If you do not know...I would change it. My PHH looked just like that yesterday with a 155k on her...until she suddenly sprung a leak. Guess what I did yesterday? At least at was at my residence and the task was on my radar. I only cussed 4 times while I changed it, once at the beginning, twice in the middle and once at the end! The twisted off hidden bolt tab method worked swell for me. -Good luck.
 
Fellas... thanks for the feedback; it is very appreciated. Based on your sage advice, my next PM will be the PHH, and might as well do the FHH as well. Again, thanks for the thoughts and insights.
 
It is the original. Unless someone went to the hassle of using the original cotter pin style hose clamps when they replaced it. Which they wouldn't have.

This is the one I got.

1FZ-FE PHH – Kit 1
 
I just did mine with a 195k on it and it was still original and it "looked ok" from the outside and not much different than yours. The thing was a hard as a rock when I finally got it off, razor knife would hardly bite it to it. It was also still original so I replaced it with some blue high temp Silicon hose and some fancy constant tension hose clamps, I had to use a BIG crow bar to get enough lift on the hard pipe and forward push at the same time to get it line up enough to slide back on.

That's why I assembled mine in reverse order. Removed the hard pipe, installed PHH to pipe, then reinstalled everything from the bottom, up.

Just a suggestion....
 
If the replacement part is bought at the dealer, it looks like that, so hard to say if it's original? Looks to be in good condition.
 
At 253k, Id change as soon as possible...
 
i replaced mine at 200k and it was perfect condition (looked like yours) and i wished i'd left it alone. it is in parts box as a spare.
the green hose does not bind to the hardlines as well and self tensioning hose clamps suck.
i've had several leaks with my replacement.
i know they fail but regular inspection will let you know if there are going to be issues. just keep an eye on it.
 
Back
Top Bottom