Opinions needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 25, 2005
Threads
41
Messages
156
Location
Bradenton, FL
Do you think this would work? There are a few details that arent shown in the drawing ie: inside the lower right side swing arm there is a welded nut to accept the bolt/pin from below. On the inside lower swing arm there is a sleeve welded in for the pivot pin to ride in. This would be for a 33x12x15. Opinions appreciated, thnx.
tirecarrier3rendered.webp
 
Back
Top Bottom