Wanted OEM Winch, Cable Lock, Wire 38143-60010 to purchase or specs for fabrication

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

LakeLaurashawn

LakeLaurashawn

SILVER Star
10 Year
Joined
Jun 13, 2014
Threads
15
Messages
133
Location
Heber UT
Website
lakelaurashawn.net
Location
United States
Morning -

I am looking to purchase Toyota Part Number 38143-60010. This is the small cable lock on the side of the cable drum for a Winch. In the attached drawing it is identified as item 'W'.

Alternatively I can fabricate one if a member is so kind as to send me the measurements or the part to replicate.

Thanks in Advance,
Lake


Screen Shot 2020-02-13 at 6.39.22 AM.webp
 
Bump!

Afternoon - I am looking to purchase Toyota Part Number 38143-60010. This is the small cable lock on the side of the cable drum for a Winch. In the attached drawing it is identified as item 'W'.

Thanks
Lake
 
Bump!

Morning All

Looking for Toyota Part Number 38143-60010. This is the small cable lock on the side of the cable drum for a Winch. In the attached drawing it is identified as item 'W'.

Thanks
Lake
 
Evening - as NORAD tracks Santa's trip, figured I'd resurrect an old request for a part!

If anyone has one, happy to buy.
If anyone has one to borrow so I can replicate - will pay for shipping and send beer in return ;-

Thanks
Lake
 
LakeLaurashawn said:
Evening - as NORAD tracks Santa's trip, figured I'd resurrect an old request for a part!

If anyone has one, happy to buy.
If anyone has one to borrow so I can replicate - will pay for shipping and send beer in return ;-

Thanks
Lake
Click to expand...
Take some 1/8” stock and make something with the right hole spacing to match the holes in the winch and radius about the same as your winch cable. If it doesn’t clamp it well enough or you can’t tighten the bolts enough make another one with a little more or less bend to it.
 
Here you go. Please bear in mind that this is not a high accuracy part. DISCLAIMER: The drawing I have made is for REFERENCE ONLY and is merely a representation of the physical part in my possession. Additionally, I understand that the drawing is not fully defined. The original dimensions were likely closer to whole number dimensions. When you draw in CAD, the model is perfect, when you punch and stamp sheet metal, it is not. This is literally a flat piece of steel bent over a rod with 2 holes in it. I hope that your reproduction adds that final detail to your project to make it as close to original as possible. Cheers.
1735923468285.png

20250103_115943.jpg

20250103_115952.jpg

20250103_120002.jpg

If anybody wants the drawing file or part file, PM me.
 

Attachments

Last edited:
LakeLaurashawn said:
Evening - as NORAD tracks Santa's trip, figured I'd resurrect an old request for a part!

If anyone has one, happy to buy.
If anyone has one to borrow so I can replicate - will pay for shipping and send beer in return ;-

Thanks
Lake
Click to expand...
Holy s***. I didn't see the part about the beer. If my drawing doesn't suffice, I'll send mine to ya in exhange for some of your finest local craft brew.
 
You must log in or register to reply here.

Share this page

Back
Top Bottom