o2 sensor troubles

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 5, 2018
Threads
15
Messages
47
Location
Philly
I reset my CEL and it came back with an o2 sensor fault before even turning the car back on. I am wondering if this an electrical issue with a connector. I purchased 2 new sensors but the shop is weary to touch the bolts on the original ones as they are very rusty.

I am going to hit the connector with a multimeter but are there any other known areas that give trouble to these sensors?

Also, if there is a fault, does the ECU just default to a fuel/air mixture?
 
If you're having a shop work on it. Trust their judgment and do what they say.

They don't come to your work and tell you how to do your job...
 
They don't want to touch it so it will be my job when they give it back :)
 
I see you are in Philadelphia. Do you have to submit your '94 for smog testing in order to pass inspection? If you don't, you can disconnect the sensors and your truck will run just fine (maybe even better than it has in a while if your sensors have been going out). You will see a CEL lit up on the dash though.
 
Mine were completely rusted. Used lots of penetrating oil, then chisel and hammer until I could get the thread to break loose. Replaced with denso sensors and have been fine since.

o2nuts.webp
 
Unfortunately I do need to pass. The engine does run fine without them connected so we are going to try a tail pipe test regardless. PA does have classic plates which could help me avoid it, just need to apply.

@FloridaCruiser22 what kinda chisel are you referring to?
 
Unfortunately I do need to pass. The engine does run fine without them connected so we are going to try a tail pipe test regardless. PA does have classic plates which could help me avoid it, just need to apply.

@FloridaCruiser22 what kinda chisel are you referring to?

I used something like this. Just held the chisel angled on the nut and kept firmly tapping with the hammer. You can see in the pic how beat up the right 2 nuts got. But there was literally nothing for a wrench or ratchet to grip to.

TEKTON 5/8 in. Cold Chisel-66006 - The Home Depot
 
I used a pair of Vise Grips on the nuts on mine. The studs are SS, the nuts are Carbon steel I believe, based on how they disintegrated. Even though the nuts were almost gone, the studs were in great shape. I ran a tap down them to clean them, used some copper anti-seize, and installed new carbon steel nuts on mine (with a lock-washer since I couldn't find all metal locking nuts)

I sprayed them well with PB Blaster first.
 
I ran a tap down them to clean them,
Not to nit pick, but you ran a threading die over those studs to clean their threads, not a tap. Taps are for cleaning, or making internal threads, and dies are for cleaning, or making external threads. Cheers!
 
Not to nit pick, but you ran a threading die over those studs to clean their threads, not a tap. Taps are for cleaning, or making internal threads, and dies are for cleaning, or making external threads. Cheers!

No, you fully intended to nit pick, ya nit pickin' monkey!


Yeah, details, details, details......

Now you sound like my wife.

Damn. Ain't no rest for the wicked.....

But, you made it all better by saying "Cheers" at the end, though ....'eh?
 
Sounds like you need a new down pipe and Maybe take the advice of people who know what's going on.

Also it sounds like your wife is a smart lady and you should listen to her.

Cheers mate
 
Back
Top Bottom