No power to Center Diff Switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

96LandcruiserPJ

SILVER Star
Joined
Dec 24, 2018
Threads
28
Messages
163
Location
Norco, CA
I just had the brakes and lift done on the 96 FZJ80. I asked them to check out why I am not getting CDL engaged (for a long while - I assumed it was that we had the vehicle sitting for a couple of years). The result was that the CD switch shows no power. Fuse is fine. Can anyone help with diagnostic to find the fault? I have installed a CDL switch in the dash, but this problem was before that installation. The connection at the switch and nearby wires appear fine.


IMG_0832.webp
 
Oops - then I guess I better locate the CDL first.
 
Put jumper wire in the harness down where it plugs into switch on the tcase, if this lights, dash wiring is good to the switch and you have a faulty or sticking switch in tcase
 
I believe there are two grounds on the harness. Mine has been modified, so I can’t point you to where they ground, but I believe both ground in the engine compartment
 
Back
Top Bottom