Never seen this

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 17, 2016
Threads
1
Messages
4
Location
James Island South Carolina
So I decided to take my 80 series through some water today! it did awesome but about 5 mins after, it started sputtering and now won't let me go over 2100 rpms it will loose power and drop to about 1500 rpms then go back to 2100 and drop over and over let it sit all day to dry out still doing it? Any ideas much appreciated
 
TPS got wet? I want to say someone else had the same issue.
 
Check for water in the distributor and spark plug tubes.
 
Like math says. Ive done this a few times spraying down the engine..:bang: grab a blow drier if your impatient.
 
How deep was the water? The videos you see if the 80's going under water are always diesels. Distributors don't like water. Neither do alternators. If you were hood deep, that was too deep.
 
I was about quarter of the way up the doors to top of the tires but I was going faster than I should have been so the insulation on the hood was soaking wet.
How deep was the water? The videos you see if the 80's going under water are always diesels. Distributors don't like water. Neither do alternators. If you were hood deep, that was too deep.
 
X1 on what Math said.
Open up your distributor cap, I'm betting you'll find water drops inside. Take your air hose and dry out the inside of the cap along the the rotor.
 
Okay so I turned my torpedo heater on in the garage and it's running good now. Wish I knew what got water in it for sure but I was thinking tps but wasn't sure. Is their anyway other than some dielectric grease to seal these parts up?
 
So I decided to take my 80 series through some water today! it did awesome but about 5 mins after, it started sputtering and now won't let me go over 2100 rpms it will loose power and drop to about 1500 rpms then go back to 2100 and drop over and over let it sit all day to dry out still doing it? Any ideas much appreciated

This behavior is almost always the TPS connector getting wet. For some reason it's not weather sealed, we apply silicone grease to prevent this in the future.
 
The dizzy has 3 vent holes in the base. Some of us have used a dab of RTV to seal off the highest one. It seems to be the most likely to pickup water that is sprayed around the engine bay from either tire splash and/or the quarter car wash.
 
The dizzy has 3 vent holes in the base. Some of us have used a dab of RTV to seal off the highest one. It seems to be the most likely to pickup water that is sprayed around the engine bay from either tire splash and/or the quarter car wash.


Never thought of just the top never wanted to block all three because they are their for a reason but that may be smart!
 
Been planning to install a small vent or filter in the breather holes for a few years, never got around to it. There was a thread four years back (see link) with photos that showed corrosion on the components under the distributor cap which occurred after the breather holes were plugged up (in a 3FE).

Here's a link to a few photos showing the location of the holes and then a distributor with internal corrosion after it was sealed up:

Plugging Distributor Vents
 
Last edited:
Back
Top Bottom