Need some help with this Safety Dash

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 17, 2019
Threads
13
Messages
103
Location
New Brunswick Canada
I have been trying to remove this upper safety bar , All bolts removed but its wedged in there and I cannot get it off.

20230409_180940.jpg


20230409_180947.jpg


20230409_180909.jpg



Any help .. What am I doing wrong.
 
If you mean the padded dash, it's five screws on the front, and then it needs to slide upward(ish) about an inch off the metal dash clips/tabs (you can see the 6 of them). It's a metal piece that clips in as well, so any corrosion will add a bit of binding.

dash.webp
 
1st, I think you need to fold the windshield down.
 
X2.....fold the windshield down
Taking the window down will be an issue onto itself. Lets just say I cannot get the window down. But that thing is not moving up , down or sideways. Will soak it with penetrating oil and see if that helps.
 
the dash pad clips over the top edge of the cowl.
the windshield frame when upright goes over the cowl holding the dahs pad in place.
not sure it is possible to remove the metal frame of the dash pad with the windshield frame in place
 
Mine wouldn't fold down either - I ended up having to pull the hinges, and the one side only freed up the pin for removal with some persuasion with the acetylene torch.

(Also kind of funny, I only installed/removed the dash with things torn apart, so never noticed that drop-the-windshield step.)
 
 
I found this thread yesterday right before I decided to tear into mine...I'm addressing my roof too and had it off ... clearly easier starting point. I ended up seeing debris and bullet shells (from PO) when I folded down - oh yeah rust. Did I open a small can of worms, yes and no - started to clean up with some clr etc - I was getting rust streaks from the dash pad on the dash - so able to clean it up better. And will take longer to get it better addressed. Glad I opened it to address it. Anyway

The pictures by @zerotreedelta helped being a noob going into it and I was still confused what/how to pry ... after the five screw and 2 screw knobs (that is a technical term for a part) were removed from the dash pad, I ended up starting on the passenger side and every one of those slots (6 of them See 1st picture as photo from the top), I lifted up the dash pad and out of the slot and moved to the left. The second picture highlights, in blue, the metal band secured to the dash pad with 9 screws - that is what is needed to be lifted out of the slots.

Last picture is a different angle of 6 slots to lift the dash pad metal bracket from the cowl.

Another note of my experience - I bought the dash pad from Toyota on their Black Friday sale online - 15% off and free shipping.

IMG_9965.jpeg


IMG_9968.jpeg


IMG_9971.jpeg


IMG_9979.jpeg
 
Last edited:
Back
Top Bottom