Need some axle advise...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 30, 2006
Threads
45
Messages
361
Location
Columbia, SC
OK, here's the situation...
I'm taking the parts from two front axles to make one good one. The first is a '76 disc axle with a butchered housing (ie no perches, turn stops, shock mounts, etc. The second is a 75 drum axle, complete with a good original housing. I've purchased the disc axle rebuild stuff from Kurt. My question is this. Should I use all of the parts off of the disc axle and only the housing from the '75? Or some other combination? How do I decide? Any advise would be appreciated.
 
The brake line junction on the '76 housing will be located on top of the diff. On the drum housing, it's on the driver side.

Should I use all of the parts off of the disc axle and only the housing from the '75?

Yes, be sure to reshim the disc knuckles to center the shaft in the housing. I would have done the mini conversion, but since you have all the parts there......
 
LC_Hamma said:
The brake line junction on the '76 housing will be located on top of the diff. On the drum housing, it's on the driver side.

Should I use all of the parts off of the disc axle and only the housing from the '75?

Yes, be sure to reshim the disc knuckles to center the shaft in the housing.


X2 You should be good to go.
 
Do I need a special tool to "reshim"

Thanks for the replies.... I assume this means I need to align the axle seal with the spindle? How would I check that?
 
FJ40-40 said:
Thanks for the replies.... I assume this means I need to align the axle seal with the spindle? How would I check that?

SST.

Try getting hold of Darin (krzyabncanuck) I believe he said he had one. Maybe he would let you borrow it.
 
Back
Top Bottom